ILSCO® ClearChoice® DBK-250 Direct Burial Underground Feeder Splice Kit, 600 V AC, 1 AWG to 250 kcmil Conductor, Aluminum
ILSCO® ClearChoice® DBK-250 Direct Burial Underground Feeder Splice Kit, 600 VAC, 1 AWG to 250 kcmil Conductor, Aluminum
-
BrandILSCO®
-
UPC783669232141
-
Manufacturer Part NumberDBK-250
-
CountryUSA
-
Cable TypeUF
-
Temperature Rating90 deg C
-
MaterialAluminum
-
TypeDirect Burial Underground Feeder
-
Conductor Size1 AWG to 250 kcmil
-
Voltage Rating600 V AC
-
SeriesDBK
-
Number of Conductors2/3
- Connector and heat shrink packaged together
- Provides maximum conductivity for UF cable
- Ensures reliability
-
Alternative Part Number7766222
-
UNSPSC39121718
-
IDEA Index ID7766222
-
Package DescriptionEACH
-
Standards/ApprovalsUL Listed|CSA Certified|PROP65: Cancer and Reproductive Harm - www.P65warnings.ca.gov
-
Specification Sheet
Recently Viewed
ILSCO® ClearChoice® DBK-250 Direct Burial Underground Feeder Splice Kit, 600 V AC, 1 AWG to 250 kcmil Conductor, Aluminum
ILSCO® ClearChoice® DBK-250 Direct Burial Underground Feeder Splice Kit, 600 VAC, 1 AWG to 250 kcmil Conductor, Aluminum
NACHI 7314B Angular Contact Ball Bearing, 70 mm Dia Bore, 150 mm OD, 1 Row, 35 mm W, 40 deg, 118000 N Dynamic/88500 N Static Load
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. The BMU bearings are commonly referred to as thrust bearings. These bearings have a 40 deg contact angle to accept heavy axial loads. The bearings have Universally Flush Ground rings to facilitate mounting in multiple bearing sets. The inner and outer rings have identical widths. These bearings can be mounted as DB, DF and DT pairs or can be combined into triplex and quadraplex sets. When two bearings are mounted together, a clearance or preload may be obtained without the use of shims or spacers. This bearing has a machined brass cage and is not available with seals or shields. These bearings are most commonly used in vertical pump and motor applications.
Morse® AV40 Master Cobalt® Heavy Duty Hole Saw, 2-1/2 in Dia, 1-1/2 in D Cutting, M3 HSS Cutting Edge
PROJECTOR BULBS
Kuri Tec® SJMD250x100 SJMD Contractor Grade Mill Single Jacket Discharge Hose, 2-1/2 in Nominal, Hose End Style, 100 ft L, 150 psi Working, Polyester/Rubber, Import
Kuri Tec® SJMD250x100 SJMD Contractor Grade Mill Single Jacket Discharge Hose, 2-1/2 in Nominal, Hose End Style, 100 ft L, 150 psi Working, Polyester/Rubber, Import
