Lifeline, Lanyard & Harness Accessories
Proto® JPCL2SS Metal Ring Tool Collar and Loop, For Use With 0.156 to 0.25 in Dia Rotating Tool, Tool Lanyard and Tether
Recently Viewed
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
Dixon® HSS312 Worm Gear Clamp, 17-1/8 to 20 in Clamp, Stainless Steel Band, Domestic
Dixon® HSS312 Worm Gear Clamp, 17-1/8 to 20 in Clamp, Stainless Steel Band, Domestic
16 TOOTH L-PITCH TIMING BELT SHEAVES-BRW16LF075X5/8 >
JASON 5VX1030 5/8" X 103" LENGTH, RUBBER V-BELT, RAW EDGE, BLACK 0.62" WIDTH.
SPECIALLY DESIGNED FOR USE ONLY 40% AS MUCH ENERGY TO BEND AROUND YOUR MACHINE'S PULLEYS AND ARE PROVEN TO OUTLAST THE COMPETITION. BELT ANGLE IS APPROXIMATELY 40 DEGREES. THE BELTS ARE CONSTRUCTED OF HIGHLY ENGINEERED AND HIGH-PERFORMANCE COMPONENTS.
-JAS5VX1030 >
EATON BR4040B200R 1-Phase Metallic Main Circuit Breaker Loadcenter, 120/240 VAC, 200 A, 40 Poles, 25 kA Interrupt
Specially designed for easy installation, EATON BR 1 in load centers house the branch circuit breakers and the wiring required to distribute power to individual circuits. They serve as main breaker for service entrances or as main lug when adding circuits to existing service. The main breaker protects the main entire panel and can be used as a service disconnect. The branch breakers protect the wires leading to individual electrical loads such as fixtures and outlets.
1.875" X 2.686" X .375" OIL SEALS-TCM182683TC >
