JASON 5VX1030 5/8" X 103" LENGTH, RUBBER V-BELT, RAW EDGE, BLACK 0.62" WIDTH.
SPECIALLY DESIGNED FOR USE ONLY 40% AS MUCH ENERGY TO BEND AROUND YOUR MACHINE'S PULLEYS AND ARE PROVEN TO OUTLAST THE COMPETITION. BELT ANGLE IS APPROXIMATELY 40 DEGREES. THE BELTS ARE CONSTRUCTED OF HIGHLY ENGINEERED AND HIGH-PERFORMANCE COMPONENTS.
-JAS5VX1030 >
Recently Viewed
JASON 5VX1030 5/8" X 103" LENGTH, RUBBER V-BELT, RAW EDGE, BLACK 0.62" WIDTH.
SPECIALLY DESIGNED FOR USE ONLY 40% AS MUCH ENERGY TO BEND AROUND YOUR MACHINE'S PULLEYS AND ARE PROVEN TO OUTLAST THE COMPETITION. BELT ANGLE IS APPROXIMATELY 40 DEGREES. THE BELTS ARE CONSTRUCTED OF HIGHLY ENGINEERED AND HIGH-PERFORMANCE COMPONENTS.
-JAS5VX1030 >
EATON BR4040B200R 1-Phase Metallic Main Circuit Breaker Loadcenter, 120/240 VAC, 200 A, 40 Poles, 25 kA Interrupt
Specially designed for easy installation, EATON BR 1 in load centers house the branch circuit breakers and the wiring required to distribute power to individual circuits. They serve as main breaker for service entrances or as main lug when adding circuits to existing service. The main breaker protects the main entire panel and can be used as a service disconnect. The branch breakers protect the wires leading to individual electrical loads such as fixtures and outlets.
1.875" X 2.686" X .375" OIL SEALS-TCM182683TC >
Browning® 1073881 Type F Q-D® Bushing, 2-1/2 in Dia Bore, 4-3/8 in Dia Barrel, 6-5/8 in Dia Flange, 3.68 in OAL, Steel
Sure-Grip® quick detachable bushings are easy to install and remove. Split-through flange and taper provide a true clamp on the shaft that is equivalent to a shrink fit. All sizes except JA and QT have a set screw over the key to help maintain the bushing's position on the shaft until the cap screws are securely tightened. Versatile Sure-Grip® bushings permit the mounting of the same mating part on shafts of different diameters and the mounting of different sheaves on the same shaft using the same bushing.
Browning 1-3/16"-ID 2-BOLT TRB PILLOW BLOCK BRW PBE-920 X 1.3/16
Browning® E920 series mounted tapered roller bearings feature durable 1-piece non-expansion housings with Type E mounting dimensions and limited misalignment. The E920 series contains setscrew locking collars for easy installation. It also contains a contact face riding seal in order to provide a good balance between contaminant entry, grease retention and friction. Depending on your application requirements, these bearings are available in a wide variety of bore sizes and housing configurations.
1" X 1" X 48" 14-GA FENCE--RL/100-JWH717969R>
