Bearing Thrust Washers

IKO Bearings WASHERS IKO AS-1528

IKO AS1528 Thrust Washer, 15 mm ID x 28 mm OD, 1 mm W

Torrington THRUST BEARING WASHERS TOR TRA-1018

Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.

Torrington THRUST BEARING WASHERS TOR TRA-1828

Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.

Torrington THRUST BEARING WASHERS TOR TRB-2435

Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.

Torrington THRUST BEARING WASHERS TOR TRC-2233

Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.

Torrington THRUST BEARING WASHERS TOR TRC-2435

Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.

Torrington THRUST NEEDLE BEARING WASHERS TOR TRD-2435

Koyo TRD-2435 Thrust Washer, 38.1 mm ID x 55.55 mm OD, 3.2 mm W