7005-L BEST GLOVES
LARGE NITRILE GLOVES--BOX OF 100-BST7005L >
Recently Viewed
LARGE NITRILE GLOVES--BOX OF 100-BST7005L >
Littelfuse® AGC1 Type 3AG Cartridge Fuse, 1 A, 32 VAC/VDC, Cartridge Body
Drillco 74A108C 7400 Center Cutting Double End Imperial Stub Length Finishing End Mill, 1/8 in Dia Cutter, 1/4 in Length of Cut, 2 Flutes, 1/8 in Dia Shank, 1-1/2 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
ALAN 14-THHN ORANGE STRANDED WIRE. THE THHN CONDUCTORS ARE PRIMARILY USED IN CONDUIT AS BRANCH CIRCUITS IN COMMERCIAL OR INDUSTRIAL APPLICATIONS.
TYPE THHN IS AVAILABLE STRANDED IN SIZES 14 AWG -750 KCMIT. THE CONDUCTORS ARE SOFT-ANNEALED, STRANDED OR SOLID COPPER AND ARE INSULATED WITH A TOUGH HEAT AND MOISTURE-RESISTANT POLYVINYL CHLORIDE, OVER WHICH A NYLON JACKSON IS APPLIED.
-ALE14THHNORG >
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing, and lubrication options or industry specific solutions.
1-1/4" PVC TRU-UNION BALL VALVE-NIBU45TBE11/4 >
