OIL SEALS
TCM25X44X7TC>
TCM25X46X7TC>
TCM25X47X10TC>
TCM25X48X7TC>
TCM25X48X8TC>
2.500" X 3.505" X .250" OIL SEAL-CHI25028 >
OIL SEALS-2.500" X 3.505" X .250"-IMS25028>
TCM250384SAY>
OIL SEALS-NAT2506>
2.500" X 3.543X.438" OIL SEAL-CHI25065 >
OIL SEALS-2.500" X 3.623" X .438"-IMS25071>
• Shaft Diameter (ID): 25.00 mm (0.984 inches)
• Housing Bore (OD): 50.00 mm (1.969 inches)
• Seal Width (Thickness): 7.00 mm (0.276 inches)
• Design Profile: Double-lip (TC Style) featuring a primary spring-loaded lip for oil/grease retention and an auxiliary dust lip to keep external dirt out of the assembly.
• Material: Nitrile Rubber (Buna-N / NBR) with a carbon steel reinforcement case and internal garter spring.
OIL SEALS-2.500" X 3.623" X .375"-CHI25074>
2.500" X 3.623" X .375" OIL SEAL - CHI25075>
OIL SEALS-2.500" X 3.502" X .406"-IMS25082>
2.500" X 3.876X.438" OIL SEAL-CHI25100 >
2.500" X 3.876X.469" OIL SEAL-CHI25102 >
OIL SEALS-2.500" X 3.876" X .469"-IMS25102>
2.500" X 4.003X3.75" OIL SEAL-CHI25108 >
OIL SEALS-.250" X .749" X .250"-CHI2512>
.250" X .749" X .250" OIL SEAL - CHI2513>
.250" X .749" X .250" OIL SEAL-CHI2514 >
OIL SEALS-2.500" X 4.938" X .500"-CHI25146>
OIL SEALS-TYPE J FLANGE SEALS-IMS25160>
Recently Viewed
Dichtomatik N70449 O-Ring, 449 Dash Number, 9.975 in ID x 10.525 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
Dichtomatik N70105 O-Ring, 105 Dash Number, 0.143 in ID x 0.349 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
250-WATT HEAT BULB WITH SAFETY SHIELD-BUL250R401SS >
