300-PC O-RING ASSORTMENTS/KITS Precision Brand PRC 12930
MADE OF BUNA-N 70 DUROMETER RUBBER COMPOUND. CREATES A TIGHT SEAL FOR FLUID OR GAS CONNECTIONS. HANDY KIT FOR SHOP TOOLROOM OR TOOLBOX
Recently Viewed
MADE OF BUNA-N 70 DUROMETER RUBBER COMPOUND. CREATES A TIGHT SEAL FOR FLUID OR GAS CONNECTIONS. HANDY KIT FOR SHOP TOOLROOM OR TOOLBOX
E7018 AC mild steel "Low Hydrogen" welding rod easily produces quality results on smaller amperage AC/DC welders. It is suitable for all positions on hardenable steels where no pre-heat is used and on cold rolled steels normally exhibiting excessive porosity when welded with conventional rod. The low hydrogen content reduces cracking and peeling of the weld material. Features excellent restart capability. Designed for welding low, medium and high carbon steels as well as some higher strength low alloy steel. For frames, trailer hitches and chassis.
Shaft Size: 5/8 inch (0.625") Materials: Buna-N elastomers (rubber), ceramic stationary ring, molded plastic primary ring, and stainless- steel hardware/springs. Design Equivalence: Equivalent to a John Crane Type 6 / Type A rotary head. Operational Limits: Rated for pressures up to 75 PSI and maximum fluid temperatures of 225°F (107°C).
1-QT CONCENTRATE PLUS ROUNDUP WEED AND GRASS KILLER - JWH714496 >
Browning® 1296417 T45L Automatic Torque Limiter, 3/4 in Finished Bore, 4-1/2 in OD, 2800 in-lb (1-Spring)/4900 in-lb (2-Spring) Torque
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
Fluke® 80T-150UA Temperature Probe, -50 to 150 deg C, 46 in L Wire
