Dixon® WA4 King Cable™ Hose Cable, 3/8 in, 44 in L, 200 psi, Carbon Steel, Domestic
Dixon® WA4 King Cable™ Hose Cable, 3/8 in, 44 in L, 200 psi, Carbon Steel, Domestic
-
BrandDixon®
-
UPC640024931685
-
Manufacturer Part NumberWA4
-
CountryUSA
-
FinishGalvanized
-
MaterialCarbon Steel
-
Nominal Size3/8 in
-
SeriesKing Cable™
-
Working Pressure200 psi
-
Domestic/ImportDomestic
-
Length44 in
- King cable is the low cost answer to eliminate injuries caused by broken air hose connection
- King safety cable reaches across the hose fittings to provide standby safety for hose
- Spring-loaded loops in the cable ends open easily to pass over the couplings for a firm grip on the hose
- Thoroughly tested with years of service, a positive safeguard for air hose connection - helps you meet today's safety standards
- Highly resistant to rust and corrosion
- Galvanized carbon steel wire rope
- Aluminum ferrule
- Galvanized carbon steel spring
- 4 in ID hose
- Cables are shipped with safety restraint labels attached
- King safety cable must be installed in the extended position (no slack)
- The Canada occupational safety and health regulations part XIII, 13:6b states: "Where an air hose is connected to a portable air powered tool used by an employee, a restraining device shall be attached to all hose connections, in order to prevent injury to an employee in the even of an accidental disconnection of a hose"
- Warning: this product contains a chemical known to the State of California to cause birth defects or other reproductive harm
- Do not use in connection with drinking water
- Wash hands after handling
-
UNSPSC40141734
-
Package Description15/BX
-
Specification Sheet
-
Catalog
Recently Viewed
Dixon® WA4 King Cable™ Hose Cable, 3/8 in, 44 in L, 200 psi, Carbon Steel, Domestic
Dixon® WA4 King Cable™ Hose Cable, 3/8 in, 44 in L, 200 psi, Carbon Steel, Domestic
1/2" -ID REINFORCE VINYL TUBE (FT)-M-MHOSE2230 >
Browning® 1296615 T65L Automatic Torque Limiter, 1-15/16 in Finished Bore, 6-1/2 in OD, 4800 in-lb (1-Spring)/8800 in-lb (2-Spring) Torque
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
1-1/16" -ID 1-3/16" -OD VITON O-RING
3.438" X 4.756" X .438"RADIAL SHAFT SEAL WITH DOUBLE METAL CASE, SKF WAVE LIP, FOR OIL OR GREASE
