Charlotte PVC 00100 1600, 6 in nominal, Hub end style, SCH 40/STD, PVC, Domestic
PVC fittings are for drain, waste and vent purposes. They are used in gravity-fed waste elimination systems and are for Non-Pressure systems where temperatures will not exceed 140° F. PVC is lightweight and
-
BrandCharlotte
-
UPC611942031931
-
Manufacturer Part NumberPVC 00100 1600
-
CountryUSA
-
Temperature Rating140 deg F
-
MaterialPVC
-
Fitting/Connector TypeCoupling
-
Pressure Rating150 psi
-
ColorWhite
-
Schedule RatingSCH 40/STD
-
Nominal Size6 in
-
Domestic/ImportDomestic
-
Length6-1/4 in
-
End StyleHub
- Easy to install
- PVC is lightweight, requires no special tools for cutting and is installed by solvent cementing
-
UNSPSC40172608
-
Package DescriptionEACH
-
Standards/ApprovalsASTM D1784|ASTM D2665|ASTM D3311|ASTM F1866|NSF 14
-
Warranty5 Years Limited
-
SDS
-
Warranty Information
-
Catalog
-
Specification Sheet
-
Instruction/Installation Manual
Recently Viewed
Charlotte PVC 00100 1600, 6 in nominal, Hub end style, SCH 40/STD, PVC, Domestic
PVC fittings are for drain, waste and vent purposes. They are used in gravity-fed waste elimination systems and are for Non-Pressure systems where temperatures will not exceed 140° F. PVC is lightweight and
HCI Preferred Supplier 20028P Union Tee, 1/4 in Nominal, Push-In, Plastic
Coilhose® B0606 Rigid Barb Fitting, 3/8 in Nominal, MPT End Style, Brass, Domestic
Coilhose® B0606 Rigid Barb Fitting, 3/8 in Nominal, MPT End Style, Brass, Domestic
FiberFix 3X3 PATCH Moisture Resistant Rigid Patch, 3 in W x 3 in L, Fiberglass, White
FiberFix rigid patch is the other cousin of the repair wrap - a fiberglass patch for permanent repairs on flat or hard-to-wrap surfaces. Simply apply the patch over the hole and expose to sunlight or UV light (but don't expose before applying!) . In 3 to 5 min after exposure, the patch will cure!.
S/S 90-DEG BULKHEAD HYD/ADAPTERS
DeWALT® Spike® 05556-PWR 1-Piece Pin Anchor, 3/8 in Dia, 6 in OAL, Mushroom Head, Carbon Steel
The Spike® is a 1-piece, vibration-resistant anchor for use in concrete block or stone. Several head styles, including tamperproof versions and anchor materials are available. The Spike® anchor is formed with an "s" shaped configuration at the working end of the anchor to create an expansion mechanism. Since the anchor is pre-formed, there is no secondary tightening operation required which greatly reduces the overall cost of an anchor installation.
