Round Linear Shaft Support Blocks
Shaft support blocks are used for end or intermittent support where loads are light and deflection between supports is not a problem. Unlike shaft support rails, blocks do not permit longitudinal passage of open-type Ball Bushing® bearings. Type SB shaft support blocks enable clamping of shafts and eliminate the need for bolts, to maintain shaft position. Shimming is suggested for high-precision applications to eliminate the effect of variations in surface of base or manufacturing tolerances between supports.
Shaft support blocks are used for end or intermittent support where loads are light and deflection between supports is not a problem. Unlike shaft support rails, blocks do not permit longitudinal passage of open-type Ball Bushing® bearings. Type SB shaft support blocks enable clamping of shafts and eliminate the need for bolts, to maintain shaft position. Shimming is suggested for high-precision applications to eliminate the effect of variations in surface of base or manufacturing tolerances between supports.
Recently Viewed
8" TENITE PLASTIC HANDLED T-BEVELS
CORD AND CABLE CONNECTOR, 3/4" HUB, 7/8" X 1-1/4, .250 - .375 CABLE RANGE-APLCG2575 >
USS SOCKET HEAD CAPSCREWS-HOL72086>
1" X 4-1/2" USS S/H CAPSCREWS-HOL72384>
The DiversiTech 36603 (commonly designated as 3660-3 or DIV36603) refers to a 36 in. x 60 in. x 3 in. lightweight outdoor equipment pad primarily engineered to support residential or industrial HVAC condensing units, heat pumps, and heavy outdoor equipment.
Milwaukee® M18 FUEL™ ANGLER™ 48-44-5195 Pulling Fish Tape Drum, 100 ft L Tape, Non-Conductive Profile, Polyester Tape
The MILWAUKEE® M18 FUEL™ ANGLER™ 100' Non-Conductive Polyester Pulling Fish Tape Replacement Cartridge is part of the world's first battery powered fish tape solution. The steel fish tape puller features AUTO-RUN™ Powered Feed and Retract that eliminates manual operation for less user fatigue and automatically reels the tape back into the Replacement Cartridge for a cleaner jobsite. The non-conductive fish tape puller has high flexibility, thicker polyester tape for easier fishing with a triple strand design to prevent kinking. The electrical fish tape with a plastic tip provides a fully non-conductive solution for maximum jobsite safety. This ANGLER™ has the ability to pull wire through a 100' run with 360° degrees of bends and is compatible with any of Milwaukee's 3 Less Binding steel and non-conductive Replacement Cartridges to tackle any situation.
