264 8"X350' BROWN GP ROLL TOWEL--CS/12
8" X 350' BROWN ROLL TOWELS--CS/12-WHY264 >
Recently Viewed
8" X 350' BROWN ROLL TOWELS--CS/12-WHY264 >
American Lock® aluminum padlock. 1-1/2 in (3.8cm) wide yellow anodized aluminum body, 1/4 in (6 mm) chrome plated, boron alloy shackle with 1-1/2 in (3.8cm) clearance. Anodized finish suitable for lockout in food processing facilities. Corrosive resistant finish for tough environments. High visibility color plus high security. Keyed alike 5-pin tumbler rekeyable cylinder. commercial boxed packaging, shelf pack quantity 6, master carton quantity 24.
IKO manufactures a wide range of radial Needle Roller Bearings to meet the needs of different applications and machine profiles. These include shell type bearings, needle roller cages for both general use and within engine connecting rods and machined type Needle Roller Bearings. Machined type Needle Roller Bearings feature low sectional height and large load ratings. A highly rigid outer ring makes these bearings ideal for light alloy housings as well.
EATON GBK14P Ground Bar Kit, 5-3/4 in L, Aluminum/Copper Conductor, 14 Terminals, For Use With Type CH/BR Loadcenter and Circuit Breaker
Specially designed for easy installation, Eaton's BR 1-inch load centers house the branch circuit breakers and the wiring required to distribute power to individual circuits. They serve as main breaker for service entrances or as main lug when adding circuits to existing service. The main breaker protects the entire panel and can be used as a service disconnect. The branch breakers protect the wires leading to individual electrical loads such as fixtures and outlets.
1-1/2" RUBBER SLIP JOINT WASHERS-RADW522 >
Browning® 1296417 T45L Automatic Torque Limiter, 3/4 in Finished Bore, 4-1/2 in OD, 2800 in-lb (1-Spring)/4900 in-lb (2-Spring) Torque
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
