Calterm 50165 Wire, Copper Conductor, 16 AWG Conductor, 2 in L, For Use With Repairs or New Wiring Applications, Domestic
Calterm 50165 Wire, Copper Conductor, 16 AWG Conductor, 2 in L, For Use With Repairs or New Wiring Applications, Domestic
-
BrandCalterm
-
UPC046494501654
-
Manufacturer Part Number50165
-
CountryUSA
-
MaterialPolyvinyl Chloride
-
ColorRed
-
Conductor Size16 AWG
-
Conductor TypeCopper
-
Accessory TypeRed Primary
-
Domestic/ImportDomestic
-
Length2 in
-
Suitable For Use WithRepairs or New Wiring Applications
-
Alternative Part Number18283125
-
UNSPSC26121524
-
IDEA Index ID18283125
-
Standards/ApprovalsNEMA Code: 0-000-1
-
Specification Sheet
Recently Viewed
Calterm 50165 Wire, Copper Conductor, 16 AWG Conductor, 2 in L, For Use With Repairs or New Wiring Applications, Domestic
Calterm 50165 Wire, Copper Conductor, 16 AWG Conductor, 2 in L, For Use With Repairs or New Wiring Applications, Domestic
4-1/2" X 5/8" -11 40-GRIT FLAP DISCS-SAI74341 >
4" X 6" .002" PLASTIC BAGS--BX/5000-ARP20F0406 >
Koyo CRS-14 Inch Series Stud Type Uncaged Needle Bearing Track Roller, 7/8 in Dia x 1/2 in W Roller, 3/8 in Dia x 0.88 in L Stud, Steel Roller
Track rollers (also known as cam followers) are characterized by their thick-walled outer rings that run directly on a track. The thick outer rings permit high load-carrying capability while minimizing both distortion and bending stresses. Sealed designs with internal thrust washers help extend service life under conditions of infrequent lubrication.
SIDE HANDLE-MWK49150265>
Martin 40BB17H 5/8 BB-H Ball Bearing Type A Idler Roller Chain Sprocket, 5/8 in Dia Bore, 2.97 in OD, 40 Chain, 17 Teeth, 1/2 in Pitch, Steel
Martin idlers are smooth-running and available in oil-impregnated, sintered bronze, extra-duty bearing press-fitted in sprocket and a hardened steel journal case for maximum resistance to wear. Steel sprockets used in Martin idlers are accurately machined (not stamped) the same as sprockets normally supplied for power transmission use. Martin can also alter existing sprockets and install bearings to make custom idlers.
