EasyHeat® AHB-130 Pre-Terminated Water Pipe Heating Cable, 120 V AC, 1.8 A
EasyHeat® AHB automatic electric water pipe heating cable is a preassembled and ready to-install, cable that prevents metal and plastic pipes from freezing. These units are activated and de-activated by an integral energy saving thermostat. They are suitable for commercial and residential metal or plastic water supply pipes subject to freezing temperatures.
-
BrandEasyHeat®
-
UPC013627109575
-
Manufacturer Part NumberAHB-130
-
CountryUSA
-
Temperature Rating-40 deg F
-
TypePre-Terminated
-
Voltage Rating120 V AC
-
Wattage211 W
-
Amperage Rating1.8 A
-
SeriesAHB
-
Insulation MaterialXLPE
-
Jacket MaterialPVC
- Protects metal and plastic water-filled pipes up to 38 mm (1-1/2 in)in Dia
- Pre-assembled and ready to install
- Plugs into a standard 120 VAC outlet, must be GFCI protected
- Integral thermostat saves energy by powering the cable only when needed
- Durable components include tough XLPE inner insulation, continuous ground braid and weather resistant PVC outer jacket
- Pre-Terminated, Activated and De-Activated by Integral Thermostat
-
Alternative Part Number8519590
-
UNSPSC26121601
-
IDEA Index ID8519590
-
Package DescriptionEACH
-
Standards/ApprovalsCSA Certified|cUL Listed
-
Catalog
-
Specification Sheet
Recently Viewed
EasyHeat® AHB-130 Pre-Terminated Water Pipe Heating Cable, 120 V AC, 1.8 A
EasyHeat® AHB automatic electric water pipe heating cable is a preassembled and ready to-install, cable that prevents metal and plastic pipes from freezing. These units are activated and de-activated by an integral energy saving thermostat. They are suitable for commercial and residential metal or plastic water supply pipes subject to freezing temperatures.
ITM 219CO1764 Heavy Duty Drill Bit, 17/64 in Drill - Fraction, 0.2656 Drill - Decimal Inch, 135 deg Point Angle, M35 Cobalt, Gold
ITM 219CO1764 Heavy Duty Drill Bit, 17/64 in Drill - Fraction, 0.2656 Drill - Decimal Inch, 135 deg Point Angle, M35 Cobalt, Gold
Double Row Cylindrical Bore Angular Contact Ball Bearing
Item #100760658
Unmounted, Angular Contact Bearing
1.57 in Inner Diameter
3.15 in Outer Diameter
1.19 in Width
Bearing Steel Material
THRUST BALL BEARING -NTN51201 >
Koyo IR-2424 Inch Series Regular Width Inner Ring, 1-1/2 in ID x 1-3/4 in OD, 1.515 in OAW, For Use With Inch Series Drawn Cup Needle Roller Bearing, Steel
Where it becomes impractical to meet the shaft raceway design requirements (hardness, case depth, surface finish, etc.) outlined in the engineering section, standard inner rings for drawn cup bearings are available. Inner rings for drawn cup bearings are designed to be a loose transition fit on the shaft and should be clamped against a shoulder. If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD as mounted, must not exceed the raceway diameters required by the drawn cup bearing for the particular application.
Sealmaster® 550098 RCI Mounted Tapered Roller Insert Only, 1.438 in Dia Bore, 2-7/8 in OD, 3 in W, 4760 lb Load

