Dichtomatik 75102229 O-Ring, 331 Dash Number, 2.225 in ID x 2.645 in OD, FKM, 75 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part Number75102229
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialFKM
-
ColorBlack
-
Inside Diameter2.225 in
-
Domestic/ImportImport
-
Durometer75 Shore A
-
Outside Diameter2.645 in
- Good chemical resistance to mineral oils and greases, synthetic oils and greases, motor, transmission and ATF oils up to 150 deg C
- Very good weathering, ozone and aging resistance
- Very low gas permeability
-
UNSPSC31401503
-
Standards/ApprovalsASTM D1418|AS 568B|BS 1806|JIS 2401
-
Alternative Part NumberV75331
-
Specification Sheet
-
Catalog
-
Instruction/Installation Manual
Recently Viewed
Dichtomatik 75102229 O-Ring, 331 Dash Number, 2.225 in ID x 2.645 in OD, FKM, 75 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
OIL SEALS-1.535" X 2.913" X .433"-IMS550234>
THRUST BALL BEARING-FAG7212B>
4" -FEMALE PIPE THREAD 45-DEGREE BLACK ELBOW-JPW4B45 >
REED offers a variety of pipe cutters, both with and without guides. Standard pipe cutters without guides feature strong malleable iron frames. These pipe cutters work on steel, stainless steel, galvanized steel or cast iron pipe, depending on the installed cutter wheels. (Models ship with cutter wheels for steel.) The wide rollers help create square cuts. REED's thin profile, sharp cutter wheels allow shorter handles for work in smaller spaces. These pipe cutters leave no burr, which is great for threading jobs. The 2-3 pipe cutter with three wheels (and no rollers) means more cutting surface and less handle swing.
3/8" BLACK UNION 3000 LB-FIT3/8BU3000 >
