Dichtomatik V75141 O-Ring, 141 Dash Number, 2.3 in ID x 2.506 in OD, FKM, 75 Shore A Durometer, Import, Custom 141-VITON
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part NumberV75141
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialFKM
-
ColorBlack
-
Inside Diameter2.3 in
-
Domestic/ImportImport
-
Durometer75 Shore A
-
Outside Diameter2.506 in
- Good chemical resistance to mineral oils and greases, synthetic oils and greases, motor, transmission and ATF oils up to 150 deg C
- Very good weathering, ozone and aging resistance
- Very low gas permeability
-
UNSPSC31401503
-
Standards/ApprovalsASTM D1418|AS 568B|BS 1806|JIS 2401
-
Instruction/Installation Manual
-
Specification Sheet
-
Catalog
Recently Viewed
Dichtomatik V75141 O-Ring, 141 Dash Number, 2.3 in ID x 2.506 in OD, FKM, 75 Shore A Durometer, Import, Custom 141-VITON
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
12-GROOVE BANDED C-225 V-BELT - JAS12RC225>
National Hardware® N151-654 V834 Standard Barrel Bolt, 4 in L x 1.53 in W, 0.32 in, Steel
H-PITCHX43 TIMING BELT-JAS430H300 >
14-MM X 1.50X85-MM HEX HEAD CAPSCREW-MET96014085F >
Weiler® 08095 ST-6 Heavy-Duty Wheel Brush, 6 in Dia Brush, 1/2 in W Face, 0.016 in Dia Filament/Wire Standard/Twist Knot Filament/Wire, 1/2 to 5/8 in Arbor Hole
Weiler® 08095 ST-6 Heavy-Duty Wheel Brush, 6 in Dia Brush, 1/2 in W Face, 0.016 in Dia Filament/Wire Standard/Twist Knot Filament/Wire, 1/2 to 5/8 in Arbor Hole
