Dichtomatik 75115254 O-Ring, 244 Dash Number, 4.234 in ID x 4.512 in OD, PTFE, 55 Durometer, Import, Custom 244-TEFLON
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
-
BrandDichtomatik
-
Manufacturer Part Number75115254
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialPTFE
-
ColorWhite
-
Inside Diameter4.234 in
-
Domestic/ImportImport
-
Durometer55
-
Outside Diameter4.512 in
- Good chemical resistance to aggressive acids, bases, alcohols and oils
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|ISD Certified|NFPA Listed|PTDA Certified
-
Alternative Part NumberTEF244
-
Specification Sheet
-
Instruction/Installation Manual
-
Catalog
Recently Viewed
Dichtomatik 75115254 O-Ring, 244 Dash Number, 4.234 in ID x 4.512 in OD, PTFE, 55 Durometer, Import, Custom 244-TEFLON
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
ILSCO® ClearChoice® DBK-250 Direct Burial Underground Feeder Splice Kit, 600 V AC, 1 AWG to 250 kcmil Conductor, Aluminum
ILSCO® ClearChoice® DBK-250 Direct Burial Underground Feeder Splice Kit, 600 VAC, 1 AWG to 250 kcmil Conductor, Aluminum
NACHI 7314B Angular Contact Ball Bearing, 70 mm Dia Bore, 150 mm OD, 1 Row, 35 mm W, 40 deg, 118000 N Dynamic/88500 N Static Load
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. The BMU bearings are commonly referred to as thrust bearings. These bearings have a 40 deg contact angle to accept heavy axial loads. The bearings have Universally Flush Ground rings to facilitate mounting in multiple bearing sets. The inner and outer rings have identical widths. These bearings can be mounted as DB, DF and DT pairs or can be combined into triplex and quadraplex sets. When two bearings are mounted together, a clearance or preload may be obtained without the use of shims or spacers. This bearing has a machined brass cage and is not available with seals or shields. These bearings are most commonly used in vertical pump and motor applications.
Morse® AV40 Master Cobalt® Heavy Duty Hole Saw, 2-1/2 in Dia, 1-1/2 in D Cutting, M3 HSS Cutting Edge
PROJECTOR BULBS
