Dichtomatik 75102151 O-Ring, 229 Dash Number, 2.359 in ID x 2.637 in OD, FKM, 75 Shore A Durometer, Import, Custom 229-VITON
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part Number75102151
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialFKM
-
ColorBlack
-
Inside Diameter2.359 in
-
Domestic/ImportImport
-
Durometer75 Shore A
-
Outside Diameter2.637 in
- Good chemical resistance to mineral oils and greases, synthetic oils and greases, motor, transmission and ATF oils up to 150 deg C
- Very good weathering, ozone and aging resistance
- Very low gas permeability
-
UNSPSC31401503
-
Standards/ApprovalsASTM D1418|AS 568B|BS 1806|JIS 2401
-
Alternative Part NumberV75229
Recently Viewed
Dichtomatik 75102151 O-Ring, 229 Dash Number, 2.359 in ID x 2.637 in OD, FKM, 75 Shore A Durometer, Import, Custom 229-VITON
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
FHP V-BELT-JAS5L400 >
DeWALT® Guaranteed Tough® DW3128 Large Diameter Thin Kerf Circular Saw Blade, 12 in Dia x 0.069 in THK, 1 in Arbor, Carbide Blade, 80 Teeth
MCR Safety® offers a wide variety of product s to assist in the care and maintenance of your safety eyewear . From cases, cords and everything in between we have your covered for all your eyewear accessories needs. Be accessorized with MCR Safety®!.
MORSE® 57908 5943 Center Cutting Regular Length Single End End Mill, 1/8 in Dia Cutter, 1/2 in Length of Cut, 4 Flutes, 1/8 in Dia Shank, 1-1/2 in OAL, Bright
Drillco 73A128C 7300 Center Cutting Imperial Regular Length Single End Finishing End Mill, 7/16 in Dia Cutter, 1 in Length of Cut, 4 Flutes, 7/16 in Dia Shank, 2-3/4 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
