Dichtomatik S70120 O-Ring, 120 Dash Number, 0.987 in ID x 1.193 in OD, Silicone Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part NumberS70120
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialSilicone Rubber
-
ColorRed
-
Inside Diameter0.987 in
-
Domestic/ImportImport
-
Durometer70 Shore A
-
Outside Diameter1.193 in
- Good chemical stability in water (up to 100 deg C), aliphatic engine and transmission oils, animal and plant based oils and greases
- Not resistant to fuels, aromatic mineral oils, water vapor (short periods up to a maximum of 120 deg C are possible), silicone oils and greases, along with acids and alkaline compounds
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|ISD Certified|NFPA Listed|PTDA Certified
-
Specification Sheet
-
Catalog
-
Instruction/Installation Manual
Recently Viewed
Dichtomatik S70120 O-Ring, 120 Dash Number, 0.987 in ID x 1.193 in OD, Silicone Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
H-PITCHX48 DOUBLE TIMING BELT-JASD480H300 >
Dichtomatik N70438 O-Ring, 438 Dash Number, 6.225 in ID x 6.775 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
METRIC V-BELT 1432MM-JASSPA1432 >
Proto® TorquePlus™ J55200 Socket Set, Metric, 19 Pieces, For Use With Stubborn or Damaged Fastener, Satin
SP SERIES V-BELTS WERE THE FORERUNNERS OF THE RMA DEEP WEDGE, HIGH-CAPACITY V-BELT SECTIONS. THESE DEEP-WEDGE BELTS ALLOW FOR MORE POWER, HIGH SPEED RATIOS, SMALLER CENTER DISTANCES AND MORE COMPACT DRIVES. THESE V-BELTS ALSO HAVE THE UNIMATCH FEATURE.
-JASSPB2580 >
