Dichtomatik 67013398 O-Ring, 52 mm ID x 58 mm OD, FKM, 80 Shore A Durometer, Import
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
-
BrandDichtomatik
-
Manufacturer Part Number67013398
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialFKM
-
ColorBlack
-
Inside Diameter52 mm
-
Domestic/ImportImport
-
Durometer80 Shore A
-
Outside Diameter58 mm
- Good chemical resistance to mineral oils and greases, synthetic oils and greases, motor, transmission and ATF oils up to 150 deg C
- Very good weathering, ozone and aging resistance
- Very low gas permeability
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|ISD Certified|NFPA Listed|PTDA Certified
-
Alternative Part NumberV3.00X052
-
Specification Sheet
-
Catalog
-
Instruction/Installation Manual
Recently Viewed
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
170-PSI 1/2" POP-OFF RELIEF VALVES-
22228E1AK.M.C3.E42A Dodge® 422017 Tapered Spherical Roller Bearing, 4-15/16 to 5 in Dia Bore, 250 mm OD, 2.6772 in W, 196000 lb Dynamic Load
Dodge® ISN spherical roller bearings-the only high-capacity double-row spherical roller bearings with an effective easy-on, easy-off adapter mounting and removal system. Not only does this patented system provide a concentric grip for superior holding on the shaft, it ensures that the bearing can be mounted and dismounted in less than fifteen minutes.
Remke Tuff-Sealâ„¢ 7303-015R Closed Mesh Insulated Single Weave Wide Range Strain Relief Grip With Galvanized Steel Mesh, 1.5 to 1.7 in Cable, For Use With 2 in NPT Connector, Aluminum
Tuff-Sealâ„¢ Wire Mesh Cable Grips distribute stress over a large area to prevent damage to wire, cable and flexible conduit. They are built to perform their task over an extended period of time without loosening their hold. All Remke wire mesh grips are available in a wide selection of cable ranges and eye styles where applicable and can be used in conjunction with any RSR cord connector.
#12 X 3" Pan Head Combo Sheet Metal Screws
#10 X 3" Pan Head Combo Sheet Metal Screws
