Dichtomatik 67196563 O-Ring, 4 mm ID x 7 mm OD, FKM, 80 Shore A Durometer, Import
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
-
BrandDichtomatik
-
Manufacturer Part Number67196563
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialFKM
-
ColorBlack
-
Inside Diameter4 mm
-
Domestic/ImportImport
-
Durometer80 Shore A
-
Outside Diameter7 mm
- Good chemical resistance to mineral oils and greases, synthetic oils and greases, motor, transmission and ATF oils up to 150 deg C
- Very good weathering, ozone and aging resistance
- Very low gas permeability
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|ISD Certified|NFPA Listed|PTDA Certified
-
Alternative Part NumberV1.50X004
-
Specification Sheet
-
Catalog
-
Instruction/Installation Manual
Recently Viewed
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
Gates® Power Transmission Tri-Power® PowerBand® 2/BX58 Heavy Duty Molded Notch V-Belt, BX Section, 21/32 in W Top, 61.6 in L Outside, 13/32 in THK, EPDM
Built for superior performance on heavy duty classical cross-section drives. The raw edge, Ethylene Elastomer construction and special notch design makes the Tri-Power belt especially suited for small diameter pulleys and back side idler drives.
TCM16X40X10TC>
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
All REED cutter wheels are made from high shock-resistant tool steel, while competitive cutter wheels are made from carbon steel or still lower quality tool steel. By using this higher quality raw material, REED cutter wheels can be made thinner and can therefore cut pipe more easily and leave less burr. Also, because of their higher quality, certified material, only REED cutter wheels can be heat-treated for the perfect balance between hardness and toughness to make REED cutter wheels resist breakage and last longer.
GEARWRENCH® 80307D Socket Set, ASME B107.1, 12 Points, 1/4 in Drive, 10 Pieces, Included Socket Size: 3/16 to 11/32 in
GEARWRENCH sockets are manufactured from alloy steel for maximum durability and strength. Our off corner loading design reduces fastener rounding and the chamfered opening help guide the socket on to fasteners. Our sockets feature a double line (SAE) and knurled (metric) ring help easily identify standard and metric sockets. The 10 piece 1/4" Drive 12 Point SAE Standard Length Socket Set includes sizes: 3/16", 7/32", 1/4", 9/32", 5/16", 11/32", 3/8", 7/16", 1/2", & 9/16" and includes a socket rail for storage & organization.
