Dichtomatik N2.50X018 O-Ring, 18 mm ID x 23 mm OD, Nitrile Rubber, 70 Shore A Durometer, Domestic, Custom H-2.5 X 18
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part NumberN2.50X018
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialNitrile Rubber
-
ColorBlack
-
Inside Diameter18 mm
-
Domestic/ImportDomestic
-
Durometer70 Shore A
-
Outside Diameter23 mm
- Good chemical resistance to mineral oils and greases
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|FDA Compliant|ISD Certified|NFPA Listed|PTDA Certified
-
Specification Sheet
-
Instruction/Installation Manual
-
Catalog
Recently Viewed
Dichtomatik N2.50X018 O-Ring, 18 mm ID x 23 mm OD, Nitrile Rubber, 70 Shore A Durometer, Domestic, Custom H-2.5 X 18
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
TPR-ID SPHERICAL ROLLER BEARINGS-SNR22206K>
JET® 561774 Drill Chuck Arbor, Taper Mount, MT-3 x JT-4 Mount Taper
The Starrett 565 Drive Pin Punch is well proportioned, hardened, properly tempered, nicely finished, and have a knurled finger grip. Each punch has the size stamped on the head. 100mm (4") length, 5mm (3/16") Diameter.
Browning® offers a comprehensive line of off the shelf gears, including spur, miter and bevel as well as change gears. These are available in 20 deg pressure angle from 20 to 4 diametral pitch and 14.5 deg pressure angle from 48 to 3 diametral pitch. They are all designed to increase output, reduce costs and avoid the need for custom specials.
GP® 908UMS Standard Length Socket, 1/4 in, 8 mm Hex Socket, 6 Points
