Dichtomatik 67004010 O-Ring, 10 mm ID x 14 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-2 X10
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part Number67004010
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialNitrile Rubber
-
ColorBlack
-
Inside Diameter10 mm
-
Domestic/ImportImport
-
Durometer70 Shore A
-
Outside Diameter14 mm
- Good chemical resistance to mineral oils and greases
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|FDA Compliant|ISD Certified|NFPA Listed|PTDA Certified
-
Alternative Part NumberN2.00X010
-
Specification Sheet
-
Catalog
-
Instruction/Installation Manual
Recently Viewed
Dichtomatik 67004010 O-Ring, 10 mm ID x 14 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-2 X10
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
CARTRIDGE INSERTS W/FELT SEAL-SEARCI308 >
Porter-Cable® 44360 Carrying Case, For Use With Belt Sander and Plunge Router
Drillco 77A132C 7700 Center Cutting Imperial Regular Length Single End Ball Nose End Mill, 1/2 in Dia Cutter, 1 in Length of Cut, 4 Flutes, 1/2 in Dia Shank, 3 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life. Ball nose.
LaCrosse® 24009091-8 Waterproof Hip Boots, Men's, Resists: Slip, Steel Toe, SZ 8, 32 in L Inseam, Black, Non-Slip Sole, Rubber Upper, Rubber Midsole, Rubber Outsole
LaCrosse® 24009091-8 Waterproof Hip Boots, Men's, Resists: Slip, Steel Toe, SZ 8, 32 in L Inseam, Black, Non-Slip Sole, Rubber Upper, Rubber Midsole, Rubber Outsole
15-TOOTH #80-1 CHAIN SPROCKETS IDC 80-B-15-F-1-7/8
15 TOOTH SPROCKETS FOR #80 CHAIN
