Hand Reamers
MORSE® 21309 1602, 1-1/4 in Dia, 12-1/4 in OAL, 1-1/4 in Straight Shank, Left Helical Flute
MORSE® 21309 1602, 1-1/4 in Dia, 12-1/4 in OAL, 1-1/4 in Straight Shank, Left Hand Helical Flute
MORSE® 21254 1601 Hand Reamer, 1-1/8 in Dia x 11-5/8 in OAL, 1-1/8 in Dia Straight Shank, Straight Flute
MORSE® 21254 1601 Hand Reamer, 1-1/8 in Dia x 11-5/8 in OAL, 1-1/8 in Dia Straight Shank, Straight Flute
GENERAL® 130 T-Handle Reamer, 1/8 to 1/2 in Dia x 5-3/4 in OAL
Drillco 445E140 4450E Imperial Hand Reamer, 5/8 in Dia x 7 in OAL, Square Shank, Spiral Flute
Hand Reamers are widely used for final sizing of drilled holes. The square on the shank end is suitable for holding in a tap wrench or vise. The cutting edge is ground with a starting taper to provide easy entry.
Recently Viewed
HCI Preferred Supplier 710606 Tube To Pipe Run Tee, 3/8 in, Push-In x Push-In x MNPTF, CA377 Brass
HCI Preferred Supplier 710606 Tube To Pipe Run Tee, 3/8 in, Push-In x Push-In x MNPTF, CA377 Brass
HCI Preferred Supplier 720806 Tube To Pipe Branch Tee, 1/2 in, Push-In x Push-In x MNPTF, CA377 Brass
HCI Preferred Supplier 720806 Tube To Pipe Branch Tee, 1/2 in, Push-In x Push-In x MNPTF, CA377 Brass
