Browning 15-TOOTH #35-1 CHAIN SPROCKETS BRW H-3515 X 5/8
Browning® finished bore sprockets are offered in single strands. Offerings include 35 to 100 pitch range. Finished bore sprockets are available from 3/8 to 2-7/16 in. Hardened teeth are available up to 30 teeth.
-
BrandBrowning®
-
UPC662289272464
-
Manufacturer Part Number1127687
-
CountryUSA
-
Pitch3/8 in
-
Pitch Diameter1.804 in
-
MaterialSteel
-
Chain Size#35
-
TypeSingle Strand Finished Bore Type 1
-
Hub Diameter1-37/64 in
-
Number of Teeth15
-
Keyway Size3/16 x 3/32 in
-
Outside Diameter1.989 in
-
Length Through Bore0.766 in
-
Bore Diameter5/8 in
- Furnished with standard keyway on centerline of tooth and hollow head setscrew over keyway
- In-stock hardened sprockets are warranted to last at least twice as long as the standard (unhardened) mild steel sprockets they replace
- For use with 3/8 in pitch ANSI chain
- Additional setscrew at 90 and 180 deg to keyway
| Competitor Name | Competitor Part Number |
|---|---|
| Applied Industrial Technologies | 100802534 |
| Applied Industrial Technologies | 100802534 |
-
Alternative Part NumberH3515X5/8
-
UNSPSC31171900
-
Package Description1/PK
-
Standards/ApprovalsANSI Specified
-
Warranty1 Year
-
Instruction/Installation Manual
-
Specification Sheet
Recently Viewed
Browning® finished bore sprockets are offered in single strands. Offerings include 35 to 100 pitch range. Finished bore sprockets are available from 3/8 to 2-7/16 in. Hardened teeth are available up to 30 teeth.
Browning® 3750148 Taper Bore Bushing, 1-1/2 in Dia Bore, 4-1/4 in Dia Barrel, 2 in OAL
Porter-Cable® 43029 Router Bit, Panel Pilot Router, 1/2 in Dia Cutting, 1/2 in Dia Shank, HSS
Eklind® 51908 Hex Key, Hex Drive, Cushion Loop T-Handle Handle, ANSI B18.3, Alloy Steel, Black Oxide
Eklind® 51908 Hex Key, Hex Drive, Cushion Grip/Loop T-Handle Handle, ANSI B18.3, Alloy Steel, Black Oxide
Koyo TRC-2233 Double Direction Thrust Washer, 34.93 mm ID x 52.37 mm OD, 2.41 mm W
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
MARXMAN™ 85061 330QI General Purpose Jobber Length Drill Bit, #7 Drill - Wire, 0.201 in Drill - Decimal Inch, 118 deg Point, HSS, Black Oxide
MARXMAN™ 85061 330QI General Purpose Jobber Length Drill Bit, #7 Drill - Wire, 0.201 in Drill - Decimal Inch, 118 deg Point, HSS, Black Oxide
