Browning 13-TOOTH MPB #40-1 CHAIN SPROCKETS BRW 40-B-13
Browning®Type B minimum bore sprockets are offered in single, double and triple strands. Offerings include 25 to 200 pitch range. Minimum bore sprockets are available in bore ranges from 1/4 to 8-3/8 in.
-
BrandBrowning®
-
UPC662289119127
-
Manufacturer Part Number1122274
-
CountryUSA
-
Pitch1/2 in
-
Pitch Diameter2.089 in
-
MaterialSteel
-
Chain Size#40
-
TypeSingle Strand Minimum Bore Type B
-
Hub Diameter1-9/16 in
-
Number of Teeth13
-
Keyway Size1/4 x 1/8 in
-
Outside Diameter2.3 in
-
Length Through Bore7/8 in
-
Bore Diameter1/2 in
- Larger hub diameter allows larger bore capacity
- Lasts longer than sprockets made from low carbon steel
- Maximum bore shown will accommodate standard keyways and setscrews over keyway
- Slightly larger bores are possible with no keyway, shallow keyway or setscrew at angle to keyway
- Hub projection on one side
- High quality, high carbon steel
- For use with 1/2 in pitch ANSI chain
- Made with Minimum bore, no keyseat or setscrew
- This can be bored to size with keyseat and setscrew for a reasonable extra charge
-
Alternative Part Number40B13
-
UNSPSC31171900
-
Package DescriptionEACH
-
Standards/ApprovalsANSI Specified
-
Warranty1 Year
-
Instruction/Installation Manual
-
Specification Sheet
Recently Viewed
Browning®Type B minimum bore sprockets are offered in single, double and triple strands. Offerings include 25 to 200 pitch range. Minimum bore sprockets are available in bore ranges from 1/4 to 8-3/8 in.
V-BELT - JASC88>
Stripping bar, hexagonal, 1 1/4-pounds, 48-inch
For prying, lifting and pulling nails
Hardened and tempered claw and chisels
Press forged and heat treated for extra durability
22-OZ TRIGGER SPRAY STAIN REMOVER-JWH648868>
72" X 60" 20000-LB CAPACITY STEEL CURB ALUMINUM DOCKPLATE - VESTAS207260>
Milwaukee® 49-57-1439 Tang Drive Annular Cutter, 1-7/16 in Dia Cutter, 1 in D Cutting, Uncoated, Quick-Change Shank
Drill holes up to 3X faster and enjoy fast change-outs with the Milwaukee® 1-7/16 in. quick change tang drive Steel Hawg® cutter. This long-lasting cutter features Carbide teeth and an alternating cutting pattern to cut up to a 1 in. hole depth in steel, stainless steel, cast iron or aluminum. It leaves a ream-like finish without pre punching or pilot holes. The Steel Hawg cutter works with most electromagnetic drill presses. Use it with arbor 49-57-0012 or 49-57-0013 on Milwaukee's 4292-1 or 4297-1 magnetic drill press or arbor 49-57-0032 on Milwaukee's 4262-1 mag press.
