Gates® Power Transmission 1228V255 Bandless Multi-Speed V-Belt, 3/4 in W Top, 28 deg Groove, 26.1 in L Outside, Rubber
Power transmission systems do more than operate at constant speeds with constant outputs. Customers increasingly need variable speed systems to regulate the speed and rotational force, or output torque, of critical mechanical equipment. Our Multi-Speed belts are engineered for efficiency, energy savings and increased productivity at a wide range of speeds and speed ratios.
-
BrandGates® Power Transmission
-
UPC72053227611
-
Manufacturer Part Number1228V255
-
CountryUSA|Canada
-
MaterialRubber
-
Top Width3/4 in
-
Reinforced MaterialPolyester
-
TypeBandless
-
Groove Angle28 deg
-
Series9804
-
Outside Length26.1 in
- Notch design reduced thermal and bending stresses for longer life
- Smooth running construction for minimal vibration at high speeds
-
Alternative Part Number98040729
-
UNSPSC26111801
-
Package DescriptionEACH
-
Standards/ApprovalsARPM/RMA IP-3-2
-
Instruction/Installation Manual
-
Catalog
Recently Viewed
Gates® Power Transmission 1228V255 Bandless Multi-Speed V-Belt, 3/4 in W Top, 28 deg Groove, 26.1 in L Outside, Rubber
Power transmission systems do more than operate at constant speeds with constant outputs. Customers increasingly need variable speed systems to regulate the speed and rotational force, or output torque, of critical mechanical equipment. Our Multi-Speed belts are engineered for efficiency, energy savings and increased productivity at a wide range of speeds and speed ratios.
8-GROOVE BANDED 5-V-1000 V-BELT 100" - PIX5V1000/08>
Sealmaster 2-1/2"-ID 4-BOLT TRB PILLOW BLOCKS SEA RPB-208-C-4-CR
Sealmaster® RPB-CR self-aligning high capacity tapered roller bearings include a fluoropolymer-coated housing and locking collars. They also include stainless steel grease fittings and single lip contact seal. For corrosion resistant applications, they also include GoldPlex® FG (USDA H1) food grade grease. The fluoropolymer coating is resistant to most chemicals and hydrocarbon solvents. These bearings are used in applications where they may be subjected to moisture and corrosive and abrasive environments. Depending on your preference, these bearings are available in two or four bolt pillow blocks and four bolt flanges.
1-1/4"-ID LINEAR BEARING - THPSUPER20>
GP® 1016M Standard Length Socket, 3/8 in Drive, 16 mm Socket, 6 Points
Heavy duty needle roller bearings consists of a machined and ground channel-shaped outer ring with a complement of needle rollers and a cage. The high-strength cage retains and guides the rollers. An optional lubrication groove and hole in the outer ring facilitates re-lubrication. These bearings can be used with or without machined and ground inner ring, depending on the suitability of the shaft as a raceway surface.
