Gates® Power Transmission Hi-Power® II E180 Banded Heavy Duty V-Belt, E Section, 1-1/2 in W Top, 187 in L Outside, 29/32 in THK, EPDM
The wrapped classical section Hi-Power™ V-belt has a long reputation for reliability on agricultural and industrial applications. The arched top of the Hi-Power belt provides superior strength to prevent "dishing" and distortion of the tensile section. The cords are properly aligned, each of them carrying its full share of the load.
-
BrandGates® Power Transmission
-
UPC72053310337
-
Manufacturer Part NumberE180
-
CountryUSA|Canada
-
Thickness29/32 in
-
MaterialEPDM
-
Top Width1-1/2 in
-
Reinforced MaterialFlex-Bonded Polyester
-
TypeBanded Heavy Duty
-
Minimum Pulley Diameter11.141 in
-
Section SizeE
-
Series9006
-
Number of Ribs1
-
Outside Length187 in
- Flex-bonded cords are strongly bonded to the body of the belt resulting in equal load distribution and the absorption of bending stress without cord deterioration
- The Flex-Weave® cover is constructed for longer cover life, providing extended protection to the core of the belt from oil, dirt and heat
- Gates® curves provide proper cord support and full contact with the sheave groove for uniform loading, uniform wear and increased belt life
- Featuring a composite, multi-purpose construction, these belts resist oil and heat, ozone, sunlight, weather and aging
-
Alternative Part Number90062180
-
UNSPSC26111801
-
Package DescriptionEACH
-
Standards/ApprovalsARPM/RMA IP-3-2/IP-3-3
-
Specification Sheet
-
Catalog
-
Instruction/Installation Manual
Recently Viewed
Gates® Power Transmission Hi-Power® II E180 Banded Heavy Duty V-Belt, E Section, 1-1/2 in W Top, 187 in L Outside, 29/32 in THK, EPDM
The wrapped classical section Hi-Power™ V-belt has a long reputation for reliability on agricultural and industrial applications. The arched top of the Hi-Power belt provides superior strength to prevent "dishing" and distortion of the tensile section. The cords are properly aligned, each of them carrying its full share of the load.
JAS240L150>
JASON 1-AT-10/1500 10-MM PITCH, T10 SERIES, 150 TEETH, 1500-MM PITCH LENGTH , 6-MM SIDE
CONSISTENT DIMENSIONAL STABILITY, LOW PRE-TENSION, LOW NOISE, HIGH ABRASION RESISTANCE, LOW MAINTENANCE, HIGH FLEXIBILITY, LINEAR SPEEDS UP TO 80-M/SECOND.
- JAS16AT10/1500>
1"-ID FLAT-OD INSERT BEARING - FAFG1100KRR>
THE STANDARD TRAPEZOIDAL TOOTH TIMING BELT DESIGN PERFORMS POORLY IN HIGH TORQUE APPLICATIONS AND HIGH-POWER DRIVES AT LOWER SPEEDS. TO OVERCOME THIS DISADVANTAGE THE HIGH TORQUE BELT (HTB) WAS DEVELOPED USING A MORE EFFICIENT TOOTH PROFILE. OIL, HEAT AND ABRASION-RESISTANT
-JAS18008M40 >
#12-#10 NYLON RING TERMINAL--PK/50-PENR6C38L >
