McGill 1-1/8"-ID NEEDLE BEARINGS MCG MR-18
McGill® CAGEROL® machined race needle bearings are manufactured from bearing quality steel. Most sizes use crowned or end relieved, rollers to help reduce end stresses and allows for greater misalignment. The rollers are separated by a steel retainer (cage) to help achieve higher speeds and provide a lubricant reservoir. CAGEROL® bearings are constructed with radial lubrication hole and groove on the outer and optional inner raceway (MI series) for relubrication through the housing or shaft. Other options include a variety of seal configurations to either help prevent contaminant entry or contain the lubricant.
-
BrandMcGill®
-
UPC726166065577
-
Manufacturer Part Number5451800000
-
CountryUSA
-
Load Capacity10900 lb Dynamic/16300 lb Static
-
Cage MaterialSteel
-
Temperature Rating-20 to 250 deg F
-
Maximum Speed10700 rpm
-
Closure TypeUnsealed
-
TypeHeavy Duty Standard
-
Width1-1/4 in
-
SeriesMR Series
-
Number of Rows1
-
Bearing Material52100 Steel
-
Outside Diameter1-5/8 in
-
Bore Diameter1-1/8 in
- Machined outer race
- Needle roller with end relief
- Annular lubrication groove and holes
- Factory grease f
-
Alternative Part NumberMR 18
-
UNSPSC31171542
-
Package DescriptionEACH
-
Specification Sheet
-
Catalog
Recently Viewed
McGill® CAGEROL® machined race needle bearings are manufactured from bearing quality steel. Most sizes use crowned or end relieved, rollers to help reduce end stresses and allows for greater misalignment. The rollers are separated by a steel retainer (cage) to help achieve higher speeds and provide a lubricant reservoir. CAGEROL® bearings are constructed with radial lubrication hole and groove on the outer and optional inner raceway (MI series) for relubrication through the housing or shaft. Other options include a variety of seal configurations to either help prevent contaminant entry or contain the lubricant.
1-1/2" X 2-1/2" EXTRA HEAVY RECT DIE SPRING-LANSEHR1500250 >
Dichtomatik N2.50X016 O-Ring, 16 mm ID x 21 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-2.5 X 16
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
