McGill 1-1/2"-ID NEEDLE BEARINGS MCG MR-24
McGill® CAGEROL® machined race needle bearings are manufactured from bearing quality steel. Most sizes use crowned or end relieved, rollers to help reduce end stresses and allows for greater misalignment. The rollers are separated by a steel retainer (cage) to help achieve higher speeds and provide a lubricant reservoir. CAGEROL® bearings are constructed with radial lubrication hole and groove on the outer and optional inner raceway (MI series) for relubrication through the housing or shaft. Other options include a variety of seal configurations to either help prevent contaminant entry or contain the lubricant.
-
BrandMcGill®
-
UPC726166066253
-
Manufacturer Part Number5452400000
-
CountryUSA
-
Load Capacity13000 lb Dynamic/20800 lb Static
-
Cage MaterialSteel
-
Temperature Rating-20 to 250 deg F
-
Maximum Speed8000 rpm
-
Closure TypeUnsealed
-
TypeHeavy Duty Standard
-
Width1-1/4 in
-
SeriesMR Series
-
Number of Rows1
-
Bearing Material52100 Steel
-
Outside Diameter2-1/16 in
-
Bore Diameter1-1/2 in
- Machined outer race
- Needle roller with end relief
- Annular lubrication groove and holes
- Factory grease f
-
Alternative Part NumberMR 24
-
UNSPSC31171542
-
Package DescriptionEACH
-
Catalog
-
Specification Sheet
Recently Viewed
McGill® CAGEROL® machined race needle bearings are manufactured from bearing quality steel. Most sizes use crowned or end relieved, rollers to help reduce end stresses and allows for greater misalignment. The rollers are separated by a steel retainer (cage) to help achieve higher speeds and provide a lubricant reservoir. CAGEROL® bearings are constructed with radial lubrication hole and groove on the outer and optional inner raceway (MI series) for relubrication through the housing or shaft. Other options include a variety of seal configurations to either help prevent contaminant entry or contain the lubricant.
1-1/8" -ID JAW COUPLING HALF-LOVL100X11/8 >
Campbell® T7625104 Round Swiveling Eye Bolt Snap, 5/8 in, 3-1/8 in OAL, 5/8 in ID Eye, 70 lb Load, Polished
Campbell® can trace its beginnings back to 1834, when one of the many companies that eventually became what is today the Campbell® brand began manufacturing harnesses for horses. Over the years, countless products were added, including wire rope and chain fittings, drop forged chain hardware, high quality tackle blocks, shackles, hooks and much more.
10-MM CLS-L LINEAR SHAFT (IN)-THP10MM>
5/8" -ID JAW COUPLING HALF-LOVL075X5/8 >
The nominal size of a Taper Pipe Tap (NPT) is that of the pipe fitting to be tapped, not the actual size of the tap.
