Sealmaster 1-1/2"-ID SPH/OD INSERT BEARINGS SEA 2-18
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction.
-
BrandSealmaster®
-
UPC662461000236
-
Manufacturer Part Number700025
-
CountryUSA
-
Load Capacity7340 lb Dynamic/4467 lb Static
-
Cage MaterialBrass
-
Temperature Rating-20 to 220 deg F
-
FinishBlack Oxide Coated
-
Maximum Speed4150 rpm
-
Closure TypeDouble Seal
-
TypeNon-Expansion Standard Duty Straight Bore
-
Seal MaterialFelt
-
Width1-15/16 in
-
Bearing MaterialSteel
-
Outside Diameter3.1496 in
-
Bore Diameter1-1/2 in
- Wide outer ring
- Lock pin and dimple system
- The felt seal with flinger provides a tight labyrinth seal which retains lubrication and acts as a filter to exclude contamination
- Single setscrew locking is 120 deg spaced, balanced three point contact minimizes inner ring distortion vibration, reduces noise and improves reliability
- Zone hardened inner race
- Land riding retainer
- Lithium complex NLGI #2 grease with an EP additive
-
Alternative Part Number2-18
-
UNSPSC31171537
-
Package DescriptionEACH
-
Instruction/Installation Manual
-
Specification Sheet
Recently Viewed
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction.
40-B-24-F-1-1/4 24 Tooth Sprockets For #40
24 TOOTH SPROCKETS FOR #40 CHAIN-IDC40B24F11/4 >
4.766" X 7.000" X 1.250" SCOTSEAL - CHI47699>
Drillco 735A116C 7350 Center Cutting Extra Long Length Imperial Single End Finishing End Mill, 1/4 in Dia Cutter, 1-1/2 in Length of Cut, 4 Flutes, 1/4 in Dia Shank, 4 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life. Extra long
National Hardware® N129-221 Extra Heavy Duty T-Hinge, 48 lb Capacity, Hot Rolled Steel, Zinc Plated
26 TOOTH SPROCKETS FOR #50 CHAIN-BRWH5026X1.3/16 >
