MORSE C/Tool 1/8" C-300 CARBIDE BURR SETS MCT 59687
MORSE® 59687 5970 C-300 Burr Set, Double Cut, 9 Pieces
-
BrandMORSE®
-
UPC686125596873
-
Manufacturer Part Number59687
-
CountryUSA
-
Finish/CoatingBright
-
Head MaterialSolid Carbide
-
Series5970 C-300
-
Cut TypeDouble
-
Shank Diameter1/8 in
-
Number of Pieces9
-
UNSPSC23251706
-
Package Description1/PK
-
Standards/ApprovalsPROP65: This product contains a chemical known to the State of California to cause cancer or birth defects. For more information go to www.P65Warnings.ca.gov
-
Catalog
Recently Viewed
MORSE® 59687 5970 C-300 Burr Set, Double Cut, 9 Pieces
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction.
The 5000® Series of bearings is similar in construction to the 400® Series bearing except it has a flange on the outer ring to locate the bearing when pressed into a tube or housing, thus eliminating the need for an external mounting device. The bearings are designed for moderate loads and speeds where running accuracy and noise level requirements do not warrant the more expensive precision ground bearings. This series of bearings feature a full ball complement without a retainer. The rings are case hardened and the soft steel band on the outer ring of the unitized assembly allows the bearing to be pressed into a housing without the necessity of close housing tolerances. The bearings are supplied pregreased as a standard. The bearings are designed for use in applications with speeds not exceeding 1200 rpm.
50-B-17-F-5/8 17 Tooth Sprockets For #50
17 TOOTH SPROCKETS FOR #50 CHAIN-IDC50B17F5/8 >
Dichtomatik 67004150 O-Ring, 20 mm ID x 26 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-3X20
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
MORSE® 96512 4554G Ball Nose Center Cutting Regular Length Single End End Mill, 1/4 in Dia Cutter, 5/8 in Length of Cut, 4 Flutes, 3/8 in Dia Shank, 2-7/16 in OAL, TiN Coated
