EF-25-B FRANKLIN AUTOMATION DELTROL 3/8 FLOW CONTROL VALVE
Size: 3/8" NPT female pipe ports Max Pressure: 2,000 psi (138 bar) Max Flow Rate: 10.0 gpm (37.9 lpm) Flow Rate (Cv): 0.76Temperature Range: -30°F to +200°F
Recently Viewed
Size: 3/8" NPT female pipe ports Max Pressure: 2,000 psi (138 bar) Max Flow Rate: 10.0 gpm (37.9 lpm) Flow Rate (Cv): 0.76Temperature Range: -30°F to +200°F
BEARING-GENPBR412>
FLANGE, 3" 200 PSI, COUPLING, 4-7/16" O.D.
BANJO M-200-FPT 2" FLANGE X 2" PIPE THREAD BRASS EXTERIOR FINISH
THE BANJO FLANGED CROSS IS AN EASY-TO-USE FITTING. IT INCLUDES POSITIVE SEALS WITH EASY ON/OFF HOSE CONNECTIONS. BUILDT WITH 360 DEGREE SEAL ORIENTATION AND A FITTING PRESSURE UP TO 125 PSI
-BAJM200CR >
Proto® Press-N-Pull™ J4242 2-Leg 2-Way Puller Set, 10 ton, 14 in Max Reach, 11 in Max Spread
Milwaukee® 48-20-5040 Heavy Duty Thin Wall Core Bit, 2-1/2 in Drill - Fraction, 2.5 in Drill - Decimal Inch
Milwaukee's Carbide tipped core bits are ideal for drilling large holes where the depth is relatively shallow. The core bit cuts a Kerf only. The usable depth of thin wall core bits ranges from 2-13/16 in. to 3-3/16 in. The thin wall construction is ideal for smaller hammers and newer concrete. The inside core must be removed by the operator before deeper drilling can be accomplished. Multiple extensions and adapters are available to allow for deeper holes to be drilled. The appropriate drive shank must be used to drive the core bit. Use of center pin and guide plate is recommended for positioning and starting a 1-1/4 in. hole and larger. Use of center pin and guide plate is not recommended for positioning and starting a 1-1/8 in. hole or smaller. Milwaukee Carbide tipped core bits are available from 1 in. to 6 in. diff. Includes core bit centering pin and guide plate.
