57601 Crowfoot-type Electrical
CROWFOOT-TYPE ELECTRICAL MALE PLUG-FOR57601>
Recently Viewed
CROWFOOT-TYPE ELECTRICAL MALE PLUG-FOR57601>
MORSE® 11082 1322 General Purpose Taper Length Drill, #29 Drill - Wire, 0.136 in Drill - Decimal Inch, 5-3/8 in OAL, HSS, Black Oxide
MORSE® 11082 1322 General Purpose Taper Length Drill, #29 Drill - Wire, 0.136 in Drill - Decimal Inch, 5-3/8 in OAL, HSS, Black Oxide
DOUBLE SEALED BALL BEARING-GUL16162RS >
ASP1312-S Industry Standard Clamping Collar, 2-Piece Construction, 1-5/16 in ID x 2-1/8 in OD x 9/16 in W, Steel
Black Oxide Plated Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
Klein Tools Full Brim Hard Hat Earmuffs are designed to work with all Klein Tools Full Brim Hard Hats, and are intended to provide limited protection from harmful noise. Tested in accordance with ANSI S3.19-1974 standards, the NRR (noise reduction rating) for these earmuffs is 26dB. Designed for all day comfort and effective acoustic seal.
