TU-236 NEBO
KEY CHAIN NAIL CLIPPERS - NEBTU236>
Recently Viewed
KEY CHAIN NAIL CLIPPERS - NEBTU236>
Gates® Power Transmission PowerGrip® 300H100 Heavy Timing Belt, 1 in W, 30 in OAL, 1/2 in Pitch, 60 Teeth, Neoprene
The trapezoidal tooth profile of PowerGrip™ Timing belts offers a maintenance-free and economical alternative to conventional chain drives and is well suited for use in positioning applications.
Gates® Power Transmission Super HC® 5V2120 Banded Heavy Duty V-Belt, 5V Section, 5/8 in W Top, 212 in L Outside, 35/64 in THK, Chloroprene
Combines the strength of a wrapped belt construction with the economies of a narrow section V-belt. Transmits more power in a given space and allows more compact drive design than classical section V-belts. In short, it offers you more power and considerably reduces the space needed. This significantly cuts the overall drive cost. Super HC™ V-belts also have exclusive Gates construction features for longer life on your drives.
2" TWO-HOLE RIGID PIPE STRAP-ELEL6206 >
3-GROOVE BANDED 5-V-750 V-BELT - PIX5V750/03>
Milwaukee® 2562-20 M12 FUEL™ Stubby Impact Wrench, 3/8 in Drive, 550 ft-lb Torque Rating, 4.8 in OAL
The new MILWAUKEE® 3/8” Stubby Impact Wrench delivers the Most Power, Is Lighter Weight & More Compact while delivering 50% Faster Application speeds. Leveraging POWERSTATE™ Brushless Motor, The Stubby Delivers 0-3,000 RPM with up to 550 ft-lbs of Nut Busting Torque, allowing the removal of the most corroded and stubborn applications. This Milwaukee® solution delivers on performance and size, at only 2.2 lbs bare tool. Users will experience less fatigue throughout their work week while fitting into tight spaces and allowing access where larger impacts can't fit without using additional accessories or disassembling components to reach the desired fastener. Equipped with Tri LED work lights to illuminate your work area without the frustration of shadows. 4-Mode DRIVE CONTROL™ for greater precision and customization to your desired power output, including AUTO SHUT-OFF™ that applies no more than 15 ft-lbs of torque for hand-tight applications that prevent overtightening when in forward. In reverse, bolt removal mode will slow down the RPM once the bolt is free to prevent bolts from flying around your work area. To change the modes, it is a single-handed operation. By shifting the forward-reverse shuttle into neutral and double-tapping the trigger, you will be able to change modes effortlessly.
