60-B-TL-11 11 Tooth Taper-lock Sprockets For #60
11 TOOTH TAPER-LOCK SPROCKETS FOR #60 CHAIN-IDC60BTL11 >
Recently Viewed
11 TOOTH TAPER-LOCK SPROCKETS FOR #60 CHAIN-IDC60BTL11 >
Hougen® Rotabroach® 12230 12000 Annular Cutter, 15/16 in Dia Cutter, 2 in D Cutting, M2 HSS, Bright, Weldon with 2-Flat Shank
Hougen "12000 Series" cutters were the original annular cutters invented over 35 years ago. With the most features of any annular cutter, "12000 Series" cutters provide the best performance in the largest variety of materials. Compared to traditional tooling (twist drills, etc.) "12000 Series" cutters can multiply your cutting speed by up to 3 times. And you get longer tool life, a more accurate hole, a better finish, with no burrs. Hougen cutters maximize feed rates because up to 10 cutting edges distribute the cutting load evenly. "12000 Series" cutters convert a smaller area to chips, requiring less horsepower and thrust.
19 TOOTH SPROCKETS FOR #40 CHAIN-IDC40BTL19 >
FLCTE-1.3/16 1-3/16"-ID 2 Bolt Flange Units-inaflcte1.
1-3/16"-ID 2 BOLT FLANGE UNITS-INAFLCTE1.3/16>
Gates® Power Transmission Hi-Power® II C83 Banded Heavy Duty V-Belt, C Section, 7/8 in W Top, 87 in L Outside, 17/32 in THK, EPDM
The wrapped classical section Hi-Power™ V-belt has a long reputation for reliability on agricultural and industrial applications. The arched top of the Hi-Power belt provides superior strength to prevent "dishing" and distortion of the tensile section. The cords are properly aligned, each of them carrying its full share of the load.
Milwaukee® 49-59-2081 Annular Cutter, 13/16 in Dia Cutter, 2 in D Cutting, HSS, Oxide Treated, Weldon Shank
Milwaukee high speed steel annular cutters offer a thin-wall construction with an advanced tooth geometry that cuts and cleans while drilling, leading to faster holes and longer life. The cutters displace less material for the same size hole as the competition, giving you fast, burr-free holes in anything from sheet metal to thick plate steel. All Milwaukee high speed steel annular cutters have a 3/4 in. Weldon shank for use with most small magnetic drill presses and large magnetic drill presses with the correct arbor.
