2-GRV A OR B-BELT H-BUSH SHEAVES IDC 2-BK-036-H
2-GRV A OR B-BELT H-BUSH SHEAVES
Recently Viewed
2-GRV A OR B-BELT H-BUSH SHEAVES
Wilton® WL9-33153 General Purpose Bench Vise, V-Groove Jaw, 2-1/2 in Jaw Opening, 3 in W Cast Iron Jaw, 2-5/8 in D Throat
Wilton clamp-on vises are great for smaller projects and are portable to be quickly and easily transferred to a new workstation. Clamp-on vises feature cast jaws for a firm hold and double steel guide bars to insure consistent holding pressure.
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing and prevents outer ring rotation within the housing. Shaft lock is achieved by either set screw or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP™ grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing and lubrication options or industry specific solutions as illustrated.
207 X 1-7/16"-ID INSERT BEARING - DOD123368>
Enerpac® RC10010 General Purpose Single Acting Spring Return Solid Plunger Hydraulic Cylinder, 103.1 ton Capacity, 5.13 in Bore, 10-1/4 in L Stroke, 17.69 in Retract, 2.81 in Dia Rod, 10000 psi Pressure
Enerpac® RC10010 General Purpose Single Acting Spring Return Solid Plunger Hydraulic Cylinder, 103.1 ton Capacity, 5.13 in Bore, 10-1/4 in L Stroke, 17.69 in Retract, 2.81 in Dia Rod, 10000 psi Pressure
Sioux Chief 524-50PK3 Metal Hanger Strap, Alternating 1/4 and 3/16 in Hole, 50 ft L x 3/4 in W, Galvanized
Sioux Chief metal hanger strap shall be used where necessary to support CTS, IPS or DWV pipe. Metal strap shall be made with galvanized or copper-plated steel and installed in accordance with national codes pertaining to hanger spacing and slope requirements. Metal hanger strap shall feature 1/4 or 3/16 in pre-drilled pilot holes in alternating pattern and strap shall be 3/4 in wide.
