VF-2-S-220-S 1-1/4" -ID 2-bolt Flange
1-1/4" -ID 2-BOLT FLANGE UNIT-BRWVF2S220S >
Recently Viewed
1-1/4" -ID 2-BOLT FLANGE UNIT-BRWVF2S220S >
BBI 455344 Partially Threaded Cap Screw, 1/2-20, 2-1/4 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 455344 Partially Threaded Cap Screw, 1/2-20, 2-1/4 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
Milwaukee® M18™ 2635-22 Double Cut Cordless Shear Kit, 18 ga Cold Rolled Steel, 22 ga Stainless Steel Cutting, 2300 spm, 15.2 in OAL, Li-Ion Battery
With the introduction of the new M18™ cordless shears, Milwaukee® has the most innovative and largest cordless shear selection on the market. By redesigning the body, we provide an in-line wrist design that maximizes control during use. Also adding the industry's only tool-free 360 deg rotating head our new shears can be used where hand snips have been needed to finish the cut. These innovations brought to each of the 3 new Milwaukee® cordless shears are changing the way tradesmen work on the jobsite today.
Milwaukee® M18™ FUEL™ 2712-20 Cordless Rotary Hammer, 1 in Keyless/SDS Plus® Chuck, 18 VDC, 1400 rpm No-Load, Li-Ion Battery
Powered by FUEL™ technology, the M18™ FUEL™ 1 in SDS Plus™ rotary hammer delivers faster than corded speed, corded durability and all day work on one charge. The Milwaukee® POWERSTATE™ brushless motor provides 1.7 ft-lb of impact energy, 0 to 1400 rpm and 0 to 4900 bpm. The Milwaukee® REDLITHIUM™ XC5 battery packs (sold separately) provide all day work on one charge, 20% more power and 2X more life than standard Lithium-Ion batteries REDLINK™ Plus™ intelligence integrates full-circle communication between tool, battery and charger to protect from overloading, overheating and over discharging.
Browning® offers a comprehensive line of off the shelf gears, including spur, miter and bevel as well as change gears. These are available in 20 deg pressure angle from 20 to 4 diametral pitch and 14.5 deg pressure angle from 48 to 3 diametral pitch. They are all designed to increase output, reduce costs and avoid the need for custom specials.
Sintered steel bushing on which the center member and friction facings rides are coated with a dry film lubricant; therefore, no oil is present to contaminate friction facings and reduce torque capacity. The bushing "free floats" on the hub. Morse® offers a wide selection of bushing widths in all torque limiter sizes, permitting close matching of center member and bushing width to minimize bearing pressure and promote longer bushing life.
