1-5/8"-ID QD SDS-STYLE BUSHINGS IDC SDS-1-5/8
1-5/8" -ID QUICK DISCONNECT SDS-STYLE BUSHING
Recently Viewed
1-5/8" -ID QUICK DISCONNECT SDS-STYLE BUSHING
ProtoĀ® J4914CF Crowfoot Wrench, 7/16 in Wrench, 3/8 in Drive, 1-3/16 in OAL, ASME B107.21, Full Polished
Drillco 72A132C 7200 Center Cutting Imperial Regular Length Single End Finishing End Mill, 1/2 in Dia Cutter, 1 in Length of Cut, 2 Flutes, 1/2 in Dia Shank, 3 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
LINEAR BEARING-INAKBZ16PP>
FEMALE PUSH ON-DEL964005 >
LittelfuseĀ® POWR-GARDĀ® LKN150 Fuse Link, 250 VAC, 150 A, For Use With RLN Series Class H Single Element Renewable/Time Delay Fuse
The LKN Series are fuse links designed for Littelfuse RLN series renewable fuses. Traditionally, Class H fuses were used to provide low cost protection of general purpose feeder and branch circuits where available short-circuit currents did not exceed 10,000 amperes. However, generally increased levels of available fault current and the distinct possibility that renewable fuses may be improperly renewed, rendering them unsafe, have all but eliminated the use of these fuses in new applications. In addition, escalating labour costs and increasing automation, which makes downtime very expensive, have greatly reduced or eliminated the cost savings attributed to renewable fuses.
