PIX A-45 IS A CLASSICAL V-BELT 47" OUTSIDE LENGTH, 1/2" TOP WIDTH, 5/16" THICKNESS, 1 RIB
OIL RESISTANT, ANTISTATIC, MAXIMUM BELT LINEAR SPEED UP TO 30M/SEC, INDUSTRIAL BELT TYPE, PRIMARILY USED AS REPLACEMENT ON INDUSTRIAL DRIVES. THE CLASSICAL BELTS ARE RECOMMENDED IN SPECIAL APPLICATIONS SUCH V-FLAT DRIVES
-PIXA45 >
Recently Viewed
PIX A-45 IS A CLASSICAL V-BELT 47" OUTSIDE LENGTH, 1/2" TOP WIDTH, 5/16" THICKNESS, 1 RIB
OIL RESISTANT, ANTISTATIC, MAXIMUM BELT LINEAR SPEED UP TO 30M/SEC, INDUSTRIAL BELT TYPE, PRIMARILY USED AS REPLACEMENT ON INDUSTRIAL DRIVES. THE CLASSICAL BELTS ARE RECOMMENDED IN SPECIAL APPLICATIONS SUCH V-FLAT DRIVES
-PIXA45 >
V-BELTS-PIXC152>
Gates® Power Transmission MegaCrimp™ 4G-2FP G25 Straight Hydraulic Coupling, 1/4 in x 1/8-27 Nominal, Hose x Female NPTF, Steel
It’s what’s inside the MegaCrimp coupling that makes it perform so well, the “C” insert. This “C” insert allows usage with different hose constructions and wall thicknesses. In addition, the C-insert ensures an even distribution of crimping forces to form a concentric seal. That simplifies your inventory requirements since one size can accommodate many different hose ODs, on both one- and two-wire braid hoses and select Xpiral hoses. An additional bonus: MegaCrimp couplings are fully qualified for SAE, EN, and ISO performance.
Klein® D2000-48-INS 2000™ Angled Head Heavy Duty Hot-Riveted Cutting Plier, 0.813 in L x 1.188 in W x 0.813 in THK Jaw Steel Jaw, 8-1/4 in OAL
These Insulated Heavy-Duty Diagonal-Cutting Pliers have durable molded insulation that is flame retardant, impact resistant and clearly marked with 1000-volt rating. The knives are heavy duty induction hardened steel that can cut ACSR, screws, nails, and most hardened wire. The high-leverage design paired with an angled head allows for increased leverage and the ability to work in confined areas.
Open up clogged grease fittings with the Grease Buster. Simply fill with a solvent and tap the piston with a hammer. The updated design includes a textured grip and two O rings on the piston. Manufactured by LockNLube in the USA. Cleans and flushes out old dried grease from fittings, pins, shafts, bushingsand joints, Uses penetrating fluid and hydraulic pressure, Reduces downtime. Much cheaper than new bearings, Hose extension and pneumatic piston available, Not for use with sealed bearings
HCI Preferred Supplier 54044 Hex Pipe Nipple, Steel, 1/4 in, MNPT
