520-J-8 JASON INDUSTRIAL PRODUCTS
8-RIB POLY-V V-BELT-JAS520J8 >
Recently Viewed
8-RIB POLY-V V-BELT-JAS520J8 >
1/4" OR 3/8" CUTOFF WHEEL ARBORS
MORSE® 58004 5944 Center Cutting Regular Length Single End End Mill, 1/16 in Dia Cutter, 3/16 in Length of Cut, 2 Flutes, 1/8 in Dia Shank, 1-1/2 in OAL, Bright
RIDGID® 32910 Screw Feed Tubing Cutter, 1/8 to 1 in Nominal, Ergonomic Grip Handle
The RIDGID Model 10 Screw Feed Tubing Cutter is designed to make clean and smooth cuts on 1/8 to 1-inch diameter copper, brass, aluminum and thin-wall steel.
Drillco 72A116C 7200 Center Cutting Imperial Regular Length Single End Finishing End Mill, 1/4 in Dia Cutter, 3/4 in Length of Cut, 2 Flutes, 1/4 in Dia Shank, 2-1/2 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
Sure-Grip® quick detachable bushings are easy to install and remove. Split-through flange and taper provide a true clamp on the shaft that is equivalent to a shrink fit. All sizes except JA and QT have a set screw over the key to help maintain the bushing's position on the shaft until the cap screws are securely tightened. Versatile Sure-Grip® bushings permit the mounting of the same mating part on shafts of different diameters and the mounting of different sheaves on the same shaft using the same bushing.
