JASON 340J6 10-RIB POLY-V V-BELT; J6 3/32" X 34"
HIGH FLEXIBILITY RUNS ON SMALL DIAMETER PULLEYS, SPEED RATIOS UP TO 60:1, MULTIPLE RIB CONSTRUCTION-ELIMINATED TURNOVER, ONE BELT PER DRIVE, REDUCED NOISE AND VIBRATION. POLYESTER TENSILE CORD PROVIDES HIGHPOWER CAPACITY, LOW STRETCH.
-JAS340J6 >
Recently Viewed
HIGH FLEXIBILITY RUNS ON SMALL DIAMETER PULLEYS, SPEED RATIOS UP TO 60:1, MULTIPLE RIB CONSTRUCTION-ELIMINATED TURNOVER, ONE BELT PER DRIVE, REDUCED NOISE AND VIBRATION. POLYESTER TENSILE CORD PROVIDES HIGHPOWER CAPACITY, LOW STRETCH.
-JAS340J6 >
BANDED V-BELT-JAS10RB162>
MICRO-V BELT, J SECTION, 4 RIBS, EPDM FOR RESISTANCE TO WEATHER, OILS, WATER, AND SOME SOLVENTS. SHORT PROFILE FOR FLEXIBILITY, REDUCED HEAT BUILDUP AND PERFORMANCE AT HIGHER SPEED. MEETS RMA OIL AND HEAT RESISTANCE STANDARDS AND STATIC CONDUCTIVITY REQUIREMENTS
- JAS290J4>
SYNTHETIC RUBBER TIMING BELT. CONFORMS TO RMA ENGINEERING STANDARD. TIMING BELTS ARE MEASURED BY LENGTH, TOOTH PITCH, THEN WIDTH. THE FIRST NUMBER IS THE LENGTH; THE LETTER AND SOMETIME NUMBER REFER TO THE TOOTH AND THE FINAL NUMBER IS THE WIDTH. STANDARD TIMING TOOTH PROFILE, H; FIBERGLASS TENSIILE MATERIAL; RUBBER OUTER MATERIAL
-JAS480H075 >
SYNTHETIC RUBBER TIMING BELT. CONFORMS TO RMA ENGINEERING STANDARD. TIMING BELTS ARE MEASURED BY LENGTH, TOOTH PITCH, THEN WIDTH. THE FIRST NUMBER IS THE LENGTH; THE LETTER AND SOMETIME NUMBER REFER TO THE TOOTH AND THE FINAL NUMBER IS THE WIDTH. STANDARD TIMING TOOTH PROFILE, H; FIBERGLASS TENSIILE MATERIAL; RUBBER OUTER MATERIAL--JAS730H200 >
JASON 200J6 MICRO-V BELT, J SECTION, 200J SIZE, 20" LENGTH, 4/7" WIDTH, 6 RIBS
HIGH FLEXIBILITY RUNS ON SMALL DIAMETER PULLEYS, SPEED RATIOS UP TO 60:1, MULTIPLE RIB CONSTRUCTION-ELIMINATED TURNOVER, ONE BELT PER DRIVE, REDUCED NOISE AND VIBRATION. POLYESTER TENSILE CORD PROVIDES HIGHPOWER CAPACITY, LOW STRETCH.
-JAS200J6 >
