3-N-08 Double Sealed Ball Bearing
Bore (Inner Diameter): 1.25 inches (31.75 mm) Outer Diameter: 2.75 inches (69.85 mm) Width (Thickness): 0.6875 inches (17.462 mm) Sealing: 2RS1 (Synthetic rubber NBR contact seals on both sides) Clearance: Normal radial internal clearance
Recently Viewed
Bore (Inner Diameter): 1.25 inches (31.75 mm) Outer Diameter: 2.75 inches (69.85 mm) Width (Thickness): 0.6875 inches (17.462 mm) Sealing: 2RS1 (Synthetic rubber NBR contact seals on both sides) Clearance: Normal radial internal clearance
Sure-Grip® quick detachable bushings are easy to install and remove. Split-through flange and taper provide a true clamp on the shaft that is equivalent to a shrink fit. All sizes except JA and QT have a set screw over the key to help maintain the bushing's position on the shaft until the cap screws are securely tightened. Versatile Sure-Grip® bushings permit the mounting of the same mating part on shafts of different diameters and the mounting of different sheaves on the same shaft using the same bushing.
NOTCHED GRIP V-BELTS-PIXAX95>
Littelfuse® POWR-GARD® LKN005 Fuse Link, 250 VAC, 5 A, For Use With RLN Series Class H Single Element Renewable/Time Delay Fuse
The LKN Series are fuse links designed for Littelfuse RLN series renewable fuses. Traditionally, Class H fuses were used to provide low cost protection of general purpose feeder and branch circuits where available short-circuit currents did not exceed 10,000 amperes. However, generally increased levels of available fault current and the distinct possibility that renewable fuses may be improperly renewed, rendering them unsafe, have all but eliminated the use of these fuses in new applications. In addition, escalating labour costs and increasing automation, which makes downtime very expensive, have greatly reduced or eliminated the cost savings attributed to renewable fuses.
Crosby® 1016912 HR-125 Swivel Hoist Ring, 2500 lb Load, 180 deg Pivot, 360 deg Swivel, 0.69 in Bail, 1/2-13 UNC Thread
Crosby® 1016912 HR-125 Swivel Hoist Ring, 2500 lb Load, 180 deg Pivot, 360 deg Swivel, 0.69 in Bail, 1/2-13 UNC Thread
GEARWRENCH® 82412-05 Handled Tip Pry Bar, Angled Tip, 12 in OAL
GEARWRENCH offers a wide range of pry bars for almost every application. The aligning and rolling head pry bars are manufactured from high alloy steel for superior strength and durability. They are ideal for prying, positioning, aligning, and lifting applications. Use the tapered end for aligning applications. The curved blade of the aligning pry bars provides extra leverage, while the rolling head provides maximum leverage. Available in sets and individually, these pry bars can handle just about any prying or aligning application.
