LJ-1-1/8 1-1/8"-ID/bore Ball Bearing
1-1/8"-ID/BORE BALL BEARING - FAFLJ11/8>
Recently Viewed
1-1/8"-ID/BORE BALL BEARING - FAFLJ11/8>
Nice® 5491VMF53 5000® Round Bore Unground Flanged Radial Ball Bearing, 1/2 in Dia Bore, 1-1/8 in OD, 1 Row, 0.437 in W, 200 lb Load
The 5000® Series of bearings is similar in construction to the 400® Series bearing except it has a flange on the outer ring to locate the bearing when pressed into a tube or housing, thus eliminating the need for an external mounting device. The bearings are designed for moderate loads and speeds where running accuracy and noise level requirements do not warrant the more expensive precision ground bearings. This series of bearings feature a full ball complement without a retainer. The rings are case hardened and the soft steel band on the outer ring of the unitized assembly allows the bearing to be pressed into a housing without the necessity of close housing tolerances. The bearings are supplied pregreased as a standard. The bearings are designed for use in applications with speeds not exceeding 1200 rpm.
Gates® Power Transmission Super HC® 3VX850 Heavy Duty Molded Notch V-Belt, 3VX Section, 3/8 in W Top, 85 in L Outside, 21/64 in THK, EPDM
Finding a belt that fits into your compact machinery without sacrificing power or efficiency is a daily challenge. When every inch of space is precious and traditional belts just don't cut it, the Super HC Molded Notch (MN) V-belt is your solution. This bandless, high-performance belt, crafted from ethylene elastomer with precision-molded notches, provides superior cord support and flexibility to improve load distribution and reduce maintenance needs. Whether you aim to boost your drive efficiency or minimize downtime, Gates Super HC MN V-belts deliver the durability and performance to keep your industrial processes running smoothly.
Heritageâ„¢ H2116Z3 45 deg Metric Zerk Form Grease Fitting, M6x0.75 Taper Thread, 23.5 mm OAL, 5.5 mm L Shank, Steel, FTG-GZ-456-M-75
Heritageâ„¢ H2116Z3 45 deg Metric Zerk Form Grease Fitting, M6x0.75 Taper Thread, 23.5 mm OAL, 5.5 mm L Shank, Steel
20-WATT 12-VOLT G-4 BASE BULBS-BULJC2020W >
The Screw-Bolt+â„¢ anchor is a one piece, heavy duty screw anchor with a finished hex head. It is simple to install, easy to identify and fully removable. The patented thread design, designed for use with standard ANSI drill bits, reduces installation torque and enhances productivity. The steel threads along the anchor body tap into the hole during installation to provide keyed engagement and allow for reduced edge and spacing distances. The Screw-Bolt+â„¢ finish is available in bright zinc plated and mechanically galvanized. Suitable base materials include normal weight concrete, sand lightweight concrete, concrete over steel deck, concrete masonry and solid clay brick.
