Recently Viewed
9/16" STEEL BALLS-SSB916 >
Dichtomatik N70329 O-Ring, 329 Dash Number, 1.975 in ID x 2.395 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
1/8" X 5/8" WOODRUFF KEYS-SIL02530 >
Power Team® C51C C Series General Purpose Spring-Return Single-Acting Hydraulic Cylinder, 5 ton Load, 4.34 in H Min, 5.44 in H Max, 1 in
Power Team® C51C C Series General Purpose Spring-Return Single-Acting Hydraulic Cylinder, 5 ton Load, 4.34 in H Min, 5.44 in H Max, 1 in
Milwaukee® 8945 3-Stage Vacuum Cleaner Motor Head, 120 VAC, 9 Point 2 A Current 134 in Sealed Suction in Water, 92 cfm Maximum Air Flow, Wet/Dry Material
This is the power unit supplied on our most powerful vacuum models. The 9.2 A motor has what it takes to handle the toughest jobs. With our listed accessories, you can bolt this unit to a 55 gallon drum and have the ultimate tool man vacuum.
The principle of a variable pitch sheave is that the threaded angular faced discs forming the V-shaped groove in which the belt rides are movable. VP sheaves consist of a male with a threaded barrel, and a female with a threaded bore. The male section with threaded barrel has flat surfaces at 180 deg increments that allow a flat surface for the setscrew to mate with. When the discs are moved toward each other, the belt rides higher in the groove and the pitch diameter of the sheave is larger which increases the driven speed. When the discs are moved away from each other, the belt rides lower and the pitch diameter is smaller decreasing the driven speed. The common term for this speed adjustment is called number of turns open from closed position.
