Recently Viewed
1/2" STEEL BALLS-SSB12 >
Koyo TRA-1018 Double Direction Thrust Washer, 15.88 mm ID x 28.58 mm OD, 0.81 mm W
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
PAINT STICKS-MRK61012>
Weiler® 44053 Scratch Brush, 5-1/2 in Brush, 14 in L x 7/8 in W Block, 1-3/16 in L Steel Trim
Weiler® 44053 Scratch Brush, 5-1/2 in Brush, 14 in L x 7/8 in W Block, 1-3/16 in L Steel Trim
Sioux® 2S2230 Z-Handle Drill, 3/8 in 3-Jaw/Key Chuck, 0.33 hp, 90 psi, 3.8 in OAL, 16 cfm Short Run Air Consumption
Sioux® 2S2230 Z-Handle Drill, 3/8 in 3-Jaw/Key Chuck, 0.33 hp, 90 psi, 3.8 in OAL, 16 cfm Short Run Air Consumption
1/4" X 36" Square Plain Keystock
