Apex® QR-108 Quick Releasing Chuck Bit Holder, 1/4 in Drive, Steel, 1/4 in Hex
Apex® QR-108 Quick Releasing Chuck Bit Holder, 1/4 in Drive, Steel, 1/4 in Hex
-
BrandApex®
-
UPC697099089025
-
Manufacturer Part NumberQR-108
-
CountryUSA
-
MaterialSteel
-
TypeQuick Releasing Chuck
-
Hex Size1/4 in
-
Diameter3/4 in
-
Drive Size1/4 in
-
Drive TypeFemale Square
-
Overall Length1-1/2 in
- Proprietary Steel and Heat Treat Process Yields Greater Strength and Longer Bit Life
- Cutting-edge Machining Process Results in Tighter Tolerances and Superior Product Consistency
- Better and More Consistent Fit to Fasteners Leads to Better Torque Transfer
-
UNSPSC27112800
-
Package DescriptionEACH
-
Catalog
Recently Viewed
Apex® QR-108 Quick Releasing Chuck Bit Holder, 1/4 in Drive, Steel, 1/4 in Hex
Apex® QR-108 Quick Releasing Chuck Bit Holder, 1/4 in Drive, Steel, 1/4 in Hex
The United Abrasives/SAIT Ovation® Flap Disc is contaminant free. The Ovation® Flap Disc is made with heavy duty zirconium grain, designed for high pressure applications. Our fiberglass backing will wear uniformly with abrasive cloth, will not splinter or smear on the workpiece. Lighter, quieter operation. Proudly manufactured in the USA.
United Abrasives-SAIT GF 77761 Close Interleaf Coated Abrasive Flap Disc, 4-1/2 in Dia, 7/8 in Center Hole, 60 Grit, Coarse Grade, Ceramic Abrasive, Type 29 Disc
Tap Magic EP-Xtra® is an ozone friendly formula that provides outstanding performance on all cuts and all metals, even hard metals such as stainless steel. The proprietary additive, EP-Xtra, provides a synergistic boost in performance. A heavy duty and versatile formula that performs incredibly on all metals and in any operation. No matter what application you have in mind, Tap Magic EP-Xtra can take care of it.
NACHI 7314B Angular Contact Ball Bearing, 70 mm Dia Bore, 150 mm OD, 1 Row, 35 mm W, 40 deg, 118000 N Dynamic/88500 N Static Load
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. The BMU bearings are commonly referred to as thrust bearings. These bearings have a 40 deg contact angle to accept heavy axial loads. The bearings have Universally Flush Ground rings to facilitate mounting in multiple bearing sets. The inner and outer rings have identical widths. These bearings can be mounted as DB, DF and DT pairs or can be combined into triplex and quadraplex sets. When two bearings are mounted together, a clearance or preload may be obtained without the use of shims or spacers. This bearing has a machined brass cage and is not available with seals or shields. These bearings are most commonly used in vertical pump and motor applications.
Proto® J226-01G Needle Nose Plier With Side Cutter and Wire Stripper, 2-5/8 in L x 3/4 in W, Diamond Serrated/Smooth Steel Jaw, 3/8 in W Tip, 7-1/2 in OAL
