HMD150 HOUGEN INTERNATIONAL
HOUGEN LOW PROFILE PORTABLE MAGNETIC DRILL-HOUHMD150 >
Recently Viewed
HOUGEN LOW PROFILE PORTABLE MAGNETIC DRILL-HOUHMD150 >
6MB-6FPX45-DAY6566>
MORSE® 17146 2330 1-Stage Type J Heavy Duty Jobber Length Aircraft Drill, 5/32 in Drill - Fraction, 0.1562 in Drill - Decimal Inch, 135 deg Point Angle, Cobalt
MORSE® 17146 2330 1-Stage Type J Heavy Duty Jobber Length Aircraft Drill, 5/32 in Drill - Fraction, 0.1562 in Drill - Decimal Inch, 135 deg Point Angle, Cobalt
Enerpac® RCH-302 Single Acting Spring Return Plunger Cylinder, 30 ton Capacity, 3-1/2 in Dia Bore, 2-1/2 in L Stroke, 7.03 in H Retract, 2-1/2 in Dia Rod, 10000 psi
Enerpac® RCH-302 Single Acting Spring Return Plunger Cylinder, 30 ton Capacity, 3-1/2 in Dia Bore, 2-1/2 in L Stroke, 7.03 in H Retract, 2-1/2 in Dia Rod, 10000 psi
MORSE® 17078 1424R Silver & Deming Drill, 1-1/4 in Drill - Fraction, 1.25 in Drill - Decimal Inch, 1/2 in Shank, HSS
MORSE® 17078 1424R Silver & Deming Drill, 1-1/4 in Drill - Fraction, 1.25 in Drill - Decimal Inch, 1/2 in Shank, HSS
Koyo TRA-1828 Double Direction Thrust Washer, 28.58 mm ID x 44.45 mm OD, 0.81 mm W
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
