60262 Chainsaw Sharpening Stone Kit,7/32" X 1/8" Shaft. Precision Ground For Quick And Easy Sharpening Of Chainsaw Blade. Maxrpm: 30,
CHAINSAW SHARPENING STONE KIT,7/32" X 1/8" SHAFT. PRECISION GROUND FOR QUICK AND EASY SHARPENING OF CHAINSAW BLADE. MAXRPM: 30,000-FOR60262 >
Recently Viewed
60262 Chainsaw Sharpening Stone Kit,7/32" X 1/8" Shaft. Precision Ground For Quick And Easy Sharpening Of Chainsaw Blade. Maxrpm: 30,
CHAINSAW SHARPENING STONE KIT,7/32" X 1/8" SHAFT. PRECISION GROUND FOR QUICK AND EASY SHARPENING OF CHAINSAW BLADE. MAXRPM: 30,000-FOR60262 >
The Schatz BR9902 (often requested with typos like zbr9902) is a high-precision, single-row deep groove radial ball bearing. Manufactured in the USA by the Schatz Bearing Corporation, it features an inch-based dimension profile and is widely used across aerospace, instrumentation, and small mechanical assemblies.
7.2-VOLT DC REMOVABLE BATTERY-MAK6320024 >
IKO IRB1416 Inch Series Inner Ring, 7/8 in ID x 1-1/8 in OD, 25.78 mm OAW, For Use With BA1816Z/BHA1816Z and YB1816 Shell Type Needle Roller Bearing, High Carbon Steel
Inner Rings can be integrated with shell-type or various machined needle roller bearings to provide good roller support without worrying about premature shaft wear. We heat-treat and grind our Inner Rings to tight tolerances to create hard, tough raceways for applications where it is impossible to make shaft surfaces to a specific hardness or roughness attribute. They're an economical alternative to bushings because they don't require any additional machining. Wide Inner Rings are also available to accommodate shafts that move axially or seals that are adjacent to bearings. Inner Rings come in a broad range of shaft diameters and assembly elements include small chamfers or gentle taper relief options. These rings are designed to provide a durable surface for shell-type needle roller bearings with non-machined raceways in-type IRB series shaft diameters range from 5/16 to 2-1/2 in.
Dichtomatik N70033 O-Ring, 033 Dash Number, 1.989 in ID x 2.129 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
