DIXON DM-26 SPHM Mender, 2 in Nominal, Import
Kuri Tec® SPHM200 SPHM Mender, 2 in Nominal, Import
-
BrandKuri Tec®
-
Manufacturer Part NumberSPHM200
-
CountryUSA
-
UPC822353110270
-
FinishZinc Plated
-
MaterialSteel
-
Fitting/Connector TypeCoupling
-
Nominal Size2 in
-
Dimensions2 in Dia
-
Domestic/ImportImport
-
Length4-9/16 in
-
End StyleHose Shank
-
SeriesSPHM
- Hose mender for repairing hoses
- Connects to a hose on both ends
- Zinc plated steel for greater corrosion resistance than unplated steel
- Barbed fitting for a tight seal on hoses
- Not for compressible products such as air, nitrogen, or steam
- For use with a hose clamps or crimp sleeve or ferrule
- Menders are not for compressible products such as air, nitrogen or steam
- The working pressure may vary with the construction of the hose, the type of clamping system used and the application
- In accordance with the R.M.A. bulletin for oil suction and discharge hose, a coupled length of hose in any size, should be tested to 1-1/2 times the working pressure and held for fifteen minutes without leaking or coupling movement
- Warning: this product contains a chemical known to the state of California to cause birth defects or other reproductive harm
- Do not use in connection with drinking water
- Wash hands after handling
| Competitor Name | Competitor Part Number |
|---|---|
| Grainger | 58DT28 |
-
UNSPSC40141734
-
Package DescriptionEACH
-
WarrantyLimited
-
Standards/ApprovalsPROP65:This product can expose you to chemicals, including lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm
-
Catalog
-
Specification Sheet
Recently Viewed
Kuri Tec® SPHM200 SPHM Mender, 2 in Nominal, Import
HCI Preferred Supplier 10017L Short Light Pattern Rod Nut, 3/8 in Nominal, SAE Flare Threaded UNF, Brass
HCI Preferred Supplier 10017L Short Light Pattern Rod Nut, 3/8 in Nominal, SAE Flare Threaded UNF, Brass
The Zamac Nailin® is a nail drive anchor which has a body formed from zamac alloy. Drive nails are available in carbon or stainless steel. The anchor can be used in concrete, block, brick or stone. A corrosion-resistant zamac alloy is used to form the anchor body with either a mushroom or flathead. The anchor can be used for light duty, tamperproof applications. The anchor is not recommend for overhead, life safety or sustained tensile loading applications (see performance data section).
EPC 10030316 104-R Solder Reducing Male Adapter, 1/2 x 3/4 in, Solder x MNPT, Copper, Domestic
The production of copper fittings is environmentally safe, and the industry is the undisputed leader in recycling. Over half of the copper used in manufacturing EPC copper fittings is from recycled sources. These solder joint fittings are available in 1/8 to 8 in sizes.
Kuri Tec® SPHM250 SPHM Mender, 2-1/2 in Nominal, Import
HCI Preferred Supplier 10078 Cap, 1/2 in Nominal, Threaded Flare UNF, Brass
