Crosby® 1037719 G-414-1/2 Extra Heavy Duty Thimble, 1/2 in, Steel, Hot Dipped Galvanized, For Use With Wire Rope
Crosby® 1037719 G-414 Extra Heavy Duty Thimble, 1/2 in, Steel, Hot Dipped Galvanized, For Use With Wire Rope
-
BrandCrosby®
-
UPC662547032342
-
Manufacturer Part Number1037719
-
CountryUSA
-
FinishHot Dipped Galvanized
-
MaterialSteel
-
TypeExtra Heavy Duty
-
SeriesG-414
-
Wire Rope Diameter1/2 in
-
Suitable For Use WithWire Rope
- Stainless steel recommended for more corrosive environments where greater protection is required
- Greater protection against wear and deformation of the wire rope eye
- Longer service life
-
UNSPSC53141603
-
Standards/ApprovalsEN13411-1:2002|Federal Spec FF-T-276b Type III
-
Catalog
Recently Viewed
Crosby® 1037719 G-414-1/2 Extra Heavy Duty Thimble, 1/2 in, Steel, Hot Dipped Galvanized, For Use With Wire Rope
Crosby® 1037719 G-414 Extra Heavy Duty Thimble, 1/2 in, Steel, Hot Dipped Galvanized, For Use With Wire Rope
United Abrasives-SAIT 25206 Type 18 Plug, 2 in Dia Maximum, A16 Grit, 5/8-11 Center Hole, Aluminum Oxide Abrasive
V-BELTOUTSIDE CIRCUMFERENCE >189"-JASC185 >
Browning 15-TOOTH P-BUSH #50 CHAIN SPROCKET BRW H-50-P-15
Browning® offers a variety of bushing type sprockets available in single and double strands. Offerings include 35 to 160 pitch range. Bushed type bore ranges are available from 1/2 to 5 in. Hardened teeth are available up to 30 teeth.
Koyo BH-812-OH Inch Series Open Ends Uncaged Drawn Cup Needle Roller Bearing With Oil Hole, 1/2 in Dia Bore, 3/4 in OD, 3/4 in W, 3910 lbf Dynamic/5790 lbf Static Load
Drawn cup needle roller bearings support radial loads and reduce friction between rotating components, with a drawn outer shell serving as a raceway for the rollers. The small cross section of the drawn cup bearing provides high load-carrying capability with minimum required space. Drawn cup bearings are easily installed with a press fit in the housing.
McGill® CAGEROL® machined race needle bearings are manufactured from bearing quality steel. Most sizes use crowned or end relieved, rollers to help reduce end stresses and allows for greater misalignment. The rollers are separated by a steel retainer (cage) to help achieve higher speeds and provide a lubricant reservoir. CAGEROL® bearings are constructed with radial lubrication hole and groove on the outer and optional inner raceway (MI series) for relubrication through the housing or shaft. Other options include a variety of seal configurations to either help prevent contaminant entry or contain the lubricant.

